IPSInternetPowerSwitch;User'sGuide
7.2. Restoring Saved Parameters
This section describes the procedure for using ProComm to send saved parameters to the IPS.
Note: Parameters that have been saved to an ASCII file can only be restored via the Text Interface. This procedure cannot be performed via the Web Browser Interface.
1.Start your communications program and access the IPS command mode via the Text Interface as described in Section 5.2.2.
2.If the Password Prompt is displayed, key in your System Level Password and press [Enter].
3.Configure your communications program to upload an ASCII text file.
4.Upload the file with the saved parameters. If necessary, key in the file name and directory path.
5.When the upload is complete, make certain to terminate the communications program's upload mode.
Note:
The current On/Off status of each IPS plug will not be saved or restored. However, the selected default On/Off setting for each plug will be saved and restored.
When the configuration file is sent to the IPS via telnet, the unit's IP Address, Subnet Mask, and Gateway Address cannot be altered.
At this point, saved parameters should have been restored to the IPS unit. Check the Plug Status Screen, General Parameters Menu, Plug Parameters Menu and Network Parameters Menu to make certain