www.unicomlink.com | UNICOM |
6.Flow Control: User can set flow control function to ON or OFF in Full Duplex mode.
7.Back Pressure: User can set backpressure to ON or OFF in Half Duplex mode.
8.Band Width: Ports 1 ~ 24 support
9.In: Type the effective port ingress rate. The valid range is 0 ~ 1000. Units are 100K.
(0) Disable rate control, 1 ~ 1000: valid rate value
10.Out: Type the effective port egress rate. The valid range is 0 ~ 1000. The unit is
100K. . (0) Disable rate control, 1 ~ 1000: valid rate value 0: disable rate control.
11.Priority: The static priority is based on each port. If you set the port to high priority, incoming frames from this port will always be high priority frames.
12.Security: A port in security mode will be “locked” without permission of address learning. Only the incoming packets with SMAC already existing in the address table can be forwarded normally. User can disable the port from learning any new MAC addresses, then use the static MAC addresses screen to define a list of MAC addresses that can use the secure port. Enter the settings and click Apply button to make changes on this page.
5-4-5. Trunking
The Link Aggregation Control Protocol (LACP) provides a standardized means for exchanging information between Partner Systems on a link. LACP allows their Link Aggregation Control instances to reach agreement on the identity of the Link Aggregation Group to which the link belongs, moves the link to that Link Aggregation Group, and enables its transmission and reception to function in an orderly manner. Basically, Link aggregation lets you group up to eight consecutive ports into a single dedicated connection. This feature can expand bandwidth to a device on the network.
LACP operation requires
56