Omega WI8XX-U manual Connector/Transmitter Types, HTTPget and ARP to Setup Device IP Address

where:

-r–Sare parameters needed for the the command string Command (See Table 4.1)

192.168.1.135 is an IP address 2000 is a socket port number

-C1closes the TCP connection after 1 second

-qdisplays no error messages once the connection is closed

	Figure 4.26 HTTPget Example of Polling End Device #2,6,7
Table 4.2 Connector/Transmitter Types
	UWTC B Type TC	221	UWTC K Type TC	230
	UWTC C Type TC	222	UWTC N Type TC	233
	UWTC E Type TC	224	UWRTD	235
	UWIR	228	UWTC R Type TC	237
	UWTC J Type TC	229	UWTC S Type TC	238
			UWTC T Type TC	239
4.5.2 HTTPget and ARP to Setup Device IP Address
	Use the iConnect software, which may be downloaded from our website,
	to do these IP changes whenever possible.
Use ARP first to assign the mac address to a static IP address in computer arp
table by this command:
arp –s 192.168.1.200 00-03-34-00-06-b6
Then use the following command to assign new IP to the device:
Httpget –r –S "00000000" 192.168.1.200:1
where:
"0000000" is admin. password. If the password is wrong, the unit will ignore the
new IP. If the new IP is taken, you will get the message "New IP is Assigned"
after the HTTPget command. The device will reset automatically.
"192.168.1.200" is an example of an IP address. It is replaced with IP address
suitable for your network
"00-03-34-00-06-b6" is replaced with your Meter’s MAC address.
		59