Omega WI8XX-U manual Rear Panel Connector, Network

2.1.2 Rear Panel

The rear panel connections are shown in Figure 2.2.

Use copper conductors only for power connections

POWER / OUTPUT

CONNECTOR

SSR RELAY PULSE

OUTPUT 1			OUTPUT 1			OUTPUT 1
NO		C	NO	NC	C	PUL		RTN
6	5	4	6	5	4	6	5	4

ANTENNA	RJ45 10BASE-T	RESET	LED
LOCATION	CONNECTION	BUTTON	INDICATORS

	POWER					ETHERNET
	L(+)	N(-)
									RST	ACTIVITY
							8	1		NET LINK
	8	7								TX
										RX
	8	7	6	OUTPUTS	1			NOT USED
ANALOG							SSR		RELAY			PULSE
OUTPUT 1						OUTPUT 2			OUTPUT 2			OUTPUT 2
CUR V RTN						NO		C	NO NC C			PUL		RTN
6	5	4				3	2	1	3	2	1	3	2	1

			8	7	6	5	4	3	2	1
	Figure 2.2 Rear Panel Power and Output Connections
POWER		Table 2.2 Rear Panel Connector
		AC/DC Power Connector: All models
OUTPUT 1		Based on one of the following models:
		Relay SPDT
		Solid State Relay (SSR)
		Pulse
OUTPUT 2		Analog Output (Voltage and Current)
		Based on one of the following models:
		Relay SPDT
		Solid State Relay (SSR)
		Pulse
Network		Communication Interface Section:
ETHERNET		RJ45 interface for 10BASE-T connection.
RESET		Button: Used for power reseting the Ethernet board.
ACTIVITY		LED (Red) Blinking: Indicates network activities (receiving or
NET LINK		sending packets).
		LED (Green) Solid: Indicates good network link.
TX		LED (Yellow) Blinking: Indicates transmitting data to the serial port.
RX		LED (Green) Blinking: Indicates receiving data on the serial port.

6