3.4.1.2Setting IP Parameters as DHCP Client
To configure the IP automatically as a DHCP client, select 9 from the Management Options screen. The Other Networking Features screen will appear.
PI
SA
Management Options | iConverter, Serial Agent |
Network Management
1:Chassis and Module Management
2:Set Module Identifier
Management Module Preferences
3:IP and Control Preferences
4:SNMP Preferences
5:Abandon Preference Changes
6:Save Preference Changes
7:Restore to Factory Defaults
8:Restart Management Module
9:Other Networking Features
Management Module Maintenance
10:Firmware Update
11:Set Date/Time
IP Address | = 192.168.1.220 |
Chassis Number = 1
Enter Choice, (H)elp, E(x)it > 9
PI
SA
Other Networking Features Screen | iConverter, Serial Agent | |
1: | Enable/Disable DHCP Client | Disabled |
2: | Enable/Disable Keep Alive Trap | Disabled |
3: | Keep Alive Trap interval | 10 |
4: | Enable/Disable SW1 Switch Block | Enabled |
5: | Serial Baud Rate | 57600 bps |
6: | Enable/Disable VLAN Support | Disabled |
7: | VLAN ID | 2 |
8: | VLAN Priority | 7 |
Enter Choice, Management Options Screen(0), (H)elp, E(x)it >
To enable DHCP client, select 1 at the Other Networking Features screen and follow the screen prompts to enable DHCP.
To save the new values, select 0 and press <ENTER> to return to the Management Options screen, then select 6 and press <ENTER> to Save Preference Changes.
3.4.1.3Setting the Chassis Number and Name
A Chassis Name, or sysName, can be assigned for identification of the GX/TM in the SNMP client. The name can be any
The Chassis Number can remain as 1 (factory default) when the GX/TM is installed without an iConverter NMM in the same chassis. When the GX/TM is installed in the same chassis as an NMM, then the GX/TM must be set to the Chassis Number of the NMM.
Page 15