Omnitron Systems Technology GX/TM user manual Installation Procedure

Page 5

19-Module Chassis

5-Module Chassis

2-Module Chassis

1-Module Redundant Chassis

3.0INSTALLATION PROCEDURE

3.1OVERVIEW

The following steps outline the installation and configuration procedures for the GX/TM. Refer to the specified sections for detailed instructions.

•Configure DIP-switches (Section 3.2)

•Installing the Module and Connecting Cables (Section 3.3)

•Configure Module via Command Line Interface (Section 3.4)

•Verify Operation (Section 3.5)

When the setup and configuration procedures are completed, the GX/TM has been configured with the basic setup requirement for standard operation. To configure the module with additional features, see Section 4.0, “Detailed Module Configuration”.

Page 5

Image 5

Contents Standalone and PLUG-IN Module Table of Contents Overview Port Structure Installation Procedure Configuring DIP-SWITCHES 1.2 SW2 UTP Auto/Manual Negotiation AN/Man 1.3 SW3 UTP Speed Gigabit/10-100 1000/10-100 Board-Mounted Bank 2 Settings These DIP-switches are for factory use only Installing PLUG-IN Modules and Connecting Cables Passwords Management Options screen will be displayed GX/TM Setting IP Parameters as Dhcp Client Setting GX/TM Passwords Setting Snmp Preferences Setting SNMPv1/v2c Read and Write Community Names Setting the Snmp Trap IP Host Addresses Vlan ID Enabling/Disabling Soft-switch Reload Access the GX/TM Remotely Updating the GX/TM Firmware via the Serial Console Port Updating the GX/TM Firmware via FTP Verify Operation NMM Detailed Module ConfigurationGX/TM LED UTPUTP HDX UTP FDX Module Management Mode Port Configuration Port Access A167EC500000 3 802.3ah Parameters OUI 4 802.3ah Events Port Vlan Page Tagged Vlan Pvid Vlan Table is Empty Vlan ID VIDUTP BP a BP B Vlan ID +1 Vlan ID CNode Loopback To refresh the Port Statistic screen, press Enter Cable Types GX/TM SpecificationsPossible Causes Troubleshooting GuideUTP Issues Limitation of Warranty Warranty