NETGEAR WG302v2 manual Appendix B Specifications, Default Factory Settings

Appendix B

Specifications

This appendix provides default factory settings and technical specifications for the ProSafe 802.11g Wireless Access Point.

Default Factory Settings

You can use the reset button located on the rear panel of your device to reset all settings to their factory defaults. This is called a hard reset. To perform a hard reset, push and hold the reset button for three seconds. Your device will return to the factory configuration settings shown in Table B-1.

Table B-1 Access Point Default Configuration Settings

Feature

AP Login

Description

	User Login URL	192.168.0.228
	User Name (case sensitive)	admin
	Login Password (case sensitive)	password
Ethernet Connection
	Ethernet MAC Address	See bottom label.
	Port Speed	10/100
Basic Settings
	AP Name	netgearxxxxxx, where xxxxxx are the last six digits of the
		wireless access point's MAC address
	Country / Region	United States (in North America; otherwise, varies by
		region)
	IP Address	192.168.0.228
	Subnet Mask	255.255.255.0
	DHCP Client	Disabled
	Spanning Tree Protocol	Enabled
	VLAN (802.1Q)	Enabled
Specifications		B-1

v1.0, May 2006