NETGEAR WG302v2 manual Entering CLI Commands, Table C-3 Commands at the Blank Prompt

NETGEAR ProSafe 802.11g Wireless Access Point WG302v2 Reference Manual

Table C-2 Interface Naming Convention (continued)

Interface	Description
lo	Local loopback for data meant for the access point itself.
eth0	The Ethernet interface connected to the Internal network.
vlan1	The VLAN interface associated with the default security profile.
wlan0	The default security profile for the Internal network.
wlan0vapx	The wireless interface for the x security profile.
wlan0wdsx	A wireless distribution system (WDS) interface where x indicates the number of the WDS
	link. The WDS interface allows you to configure wireless bridging and repeating.

Entering CLI Commands

This section describes how to use CLI commands to configure the access point and how to view system settings and information.

Table C-3shows the commands available at the blank CLI prompt. You can type TAB twice to display the list of commands. After you enter the command, press the TAB key twice to display a list of available keywords and variables.

Table C-3 Commands at the Blank Prompt

Command	Description
get	Gets the property values of existing instances of a class.
set	Sets the property values of existing instances of a class.
add	Adds a new instance or group of instances of a class.
remove	Removes an existing instance of a class.
config	Uploads or downloads the running configuration.
firmware-upgrade	Upgrades the firmware.
save-running	Saves the running configuration as the startup configuration.
reboot	Restarts the access point (a “soft” reboot).
factory-reset	Resets the AP to factory defaults and reboots.

C-4 Command Line Reference

v1.0, May 2006