NETGEAR WG302v2 manual Hotspot Settings, Advanced Wireless Settings

NETGEAR ProSafe 802.11g Wireless Access Point WG302v2 Reference Manual

Table C-14 Advanced IP Setting (continued)s

Task	Command
Set the Secondary DNS Server	set dhcp-server dns2 <ip_address>
Set the Primary WINS Server	set dhcp-server wins1 <ip_address>
Set the Secondary WINS Server	set dhcp-server wins1 <ip_address>
Set the Lease	set dhcp-server lease <seconds>

Hotspot Settings

The commands in Table C-15correspond to the Hotspot Settings page on the Web UI under the Advanced heading.

Table C-15 Hotspot Settings

Task	Command
View all HTTP redirect information	get http-redirect
Enable HTTP Redirect	set http-redirect status up
Disable HTTP Redirect	set portal status down
Set the URL for the redirect	set http-redirect url <url>

Advanced Wireless Settings

The commands in Table C-16correspond to the Wireless Settings page on the Web UI under the Advanced heading. For information about the configuration options in this section, see “Configuring Advanced Wireless Settings” on page 4-3.

Table C-16 Advanced Wireless Settings

Task Command

Enable Super-G Mode	set radio wlan0 super-ag yes
Disable Super-G Mode	set radio wlan0 super-ag no
Set the RTS Threshold	set radio wlan0 rts-threshold <0-2347>
Set the Fragmentation Length	set radio wlan0 fragmentation-threshold <256-2346>
Threshold
Set the Beacon Interval	set radio wlan0 beacon-interval <20-1000>
Command Line Reference	C-17

v1.0, May 2006