NETGEAR WG302v2 manual Radius Server Settings

NETGEAR ProSafe 802.11g Wireless Access Point WG302v2 Reference Manual

Table C-9 Security Profile Settings (continued)

Task Command

Set Network Authentication to	set interface wlan0 security wpa-enterprise
WPA and WPA2 with RADIUS	set bss wlan0bssvap0 wpa-allowed on
	set bss wlan0bssvap0 wpa2-allowed on
Enable Wireless Client Security	set radio wlan0 station-isolation on
Separation
Disable Wireless Client Security	set radio wlan0 station-isolation off
Separation
Set the VLAN ID for the Security	set vap vap0 with radio wlan0 vlan-id <1-4096>
Profile

RADIUS Server Settings

The commands in Table C-10correspond to the RADIUS Server Settings page on the Web UI.

Table C-10 RADIUS Server Settings

Task	Command
Set the IP Address of the	set radius-client
Primary Authentication Server	primary-authentication-server <ip_address>
Set the Port Number of the	set radius-client
Primary Authentication Server	primary-authentication-port <port_number>
Set the Shared Secret for the	set radius-client
Primary Authentication Server	primary-authentication-key <value>
Set the IP Address of the	set radius-client
Secondary Authentication	secondary-authentication-server <ip_address>
Server
Set the Port Number of the	set radius-client
Secondary Authentication	secondary-authentication-port <port_number>
Server
Set the Shared Secret for the	set radius-client
Secondary Authentication	secondary-authentication-key <value>
Server
Set the IP Address of the Pri-	set radius-client
mary Accounting Server	primary-accounting-server <ip_address>
C-12	Command Line Reference

v1.0, May 2006