Lucent Technologies 1100 manual Terms and Conventions, Security Alert

Page 21

About This Book

Terms and Conventions

The DEFINITY Extender 1101 System is henceforth referred to as the “Remote Module.”

The DEFINITY Extender 1100 System is henceforth referred to as the “Switch Module.”

Throughout this document, toll fraud security hazards are indicated by an exclamation point inside a triangle and the words Security Alert.

Security Alert:

Security Alert indicates the presence of toll fraud security hazard. Toll fraud is the unauthorized use of your telecommunications system by an unauthorized party (e.g., persons other than your company’s employees, agents, subcontractors, or persons working on your company’s behalf). Be sure to read “Your Responsibility for Your System’s Security” on the inside front cover of this book and “Security of Your System: Preventing Toll Fraud” in About This Book.

xviiiIssue 1 June 1998

Image 21
Contents Definity Extender Federal Communications Commission Statement Industry Canada IC Interference Information Contents Introduction Connecting the Switch Module GL-1 Figures Tables Important Safety Instructions Viii Issue 1 June Customer Support Information Support Telephone Number Security of Your System Preventing Toll Fraud Lucent Technologies Fraud Intervention Lucent Technologies Limited Warranty FCC Notification Repair Information Installation and Operational Procedures Customer Support Information Customer Support Information Xvi Issue 1 June Intended Audience About This BookSecurity Alert Terms and ConventionsTypographical Conventions How to Use This BookProduct Safety Labels Call Related DocumentsToll Fraud Security How to Comment on This Document Feedback Form This Form MAY be Photocopied Introduction1 System Configuration System Operation ConfigurationSecurity Alert Switch Module Equipment ListCustomer-Supplied Equipment Compatibility Options SpecificationsPage Switch Module Specifications Description Considerations 10Issue 1 June Password Considerations Configuration2Programming the Switch Module Page Enhanced Terminal Interface Configure System ExitTerminal Edit Line Configuring the COM RS-232D Port Configuration Stop Bits Issue 1 June 1998 Setting Data Rate Setting ParitySetting Data Bit Setting Stop Bits Show SettingsAdditional Modem Initialization Setting Passwords Security Alert Considerations Programming Passwords Procedure To check a password To disable a password Configuring Passwords OnlinePage Configuration Issue 1 June 1998 Installation3 Electrical Requirements Location RequirementsConnecting the Switch Module Wiring RequirementsSwitch Module Back Panel Installation ProcedureDIP Switch Configuration Installation Connections for Data Transmission Female Connector on Module Hardware Flow Control Installation 10Issue 1 June Troubleshooting4 Troubleshooting LED Sequences LED Power up Sequences LED Sequence Description LED Power up Verification Sequences LED Sequence Description Module is online to a Remote Module no Rgrg Error Messages Cause Action Error MessagesError Messages Cause Action Specific Problems No Display on Telephone at Remote LocationNo Connection/No Answer Page Reporting a Faulty Switch Module Troubleshooting Issue 1 June 1998 Glossary GL-2Issue 1 June Issue 1 June 1998 GL-3 GL-4Issue 1 June Issue 1 June 1998 GL-5 Glossary GL-6Issue 1 June