Lucent Technologies 1100 manual Terminal Edit Line

Page 43

Configuration

3.Press the Enter key, or 1.

The following menu is displayed on the screen:

1)Passwords

2)PBX COM port settings: 38.4 kbps N, 8, 1

3)Show Settings

4)Additional Modem Initialization

5)Software Upgrade*

6)Exit

The Terminal Edit Line

The Terminal Edit Line is where features can be entered or modified. When editing parameters on the terminal edit line, current parameters are highlighted if previously entered.

The following edit line key strokes can be used to modify parameters.

NOTE:

You can also toggle the display between ETI (Enhanced Terminal Interface) and TTI (Text Terminal Interface) modes by pressing CTRL T. TTI mode is used when user’s terminal does not support VT-100 emulation.

*For information about this feature, please contact your Lucent Technologies representative

Issue 1 June 1998 2-5

Image 43

Contents Definity Extender Federal Communications Commission Statement Industry Canada IC Interference Information Contents Introduction Connecting the Switch Module GL-1 Figures Tables Important Safety Instructions Viii Issue 1 June Customer Support Information Support Telephone Number Security of Your System Preventing Toll Fraud Lucent Technologies Fraud Intervention Lucent Technologies Limited Warranty FCC Notification Repair Information Installation and Operational Procedures Customer Support Information Customer Support Information Xvi Issue 1 June Intended Audience About This BookSecurity Alert Terms and ConventionsTypographical Conventions How to Use This BookProduct Safety Labels Call Related DocumentsToll Fraud Security How to Comment on This Document Feedback Form This Form MAY be Photocopied Introduction1 System Configuration System Operation ConfigurationSecurity Alert Equipment List Switch ModuleCustomer-Supplied Equipment Compatibility Options SpecificationsPage Switch Module Specifications Description Considerations 10Issue 1 June Password Considerations Configuration2Programming the Switch Module Page Enhanced Terminal Interface Configure System ExitTerminal Edit Line Configuring the COM RS-232D Port Configuration Stop Bits Issue 1 June 1998 Setting Parity Setting Data RateSetting Data Bit Show Settings Setting Stop BitsAdditional Modem Initialization Setting Passwords Security Alert Considerations Programming Passwords Procedure To check a password To disable a password Configuring Passwords OnlinePage Configuration Issue 1 June 1998 Installation3 Electrical Requirements Location RequirementsConnecting the Switch Module Wiring RequirementsSwitch Module Back Panel Installation ProcedureDIP Switch Configuration Installation Connections for Data Transmission Female Connector on Module Hardware Flow Control Installation 10Issue 1 June Troubleshooting4 Troubleshooting LED Sequences LED Power up Sequences LED Sequence Description LED Power up Verification Sequences LED Sequence Description Module is online to a Remote Module no Rgrg Error Messages Cause Action Error MessagesError Messages Cause Action No Display on Telephone at Remote Location Specific ProblemsNo Connection/No Answer Page Reporting a Faulty Switch Module Troubleshooting Issue 1 June 1998 Glossary GL-2Issue 1 June Issue 1 June 1998 GL-3 GL-4Issue 1 June Issue 1 June 1998 GL-5 Glossary GL-6Issue 1 June