Installation
Following installation, administer the line and station ports that use the Switch Module according to the instructions in DEFINITY® Communications System Generic 3 Implementation Guide, Issue 1, document
Follow these steps to install the Switch Module:
1.Ensure that the module has the proper DIP switch configuration (see Table
Table 3-1. DIP Switch Configuration
Switch # | OFF | ON |
|
|
|
1 | ||
|
|
|
2 | Normal operation | Reserved |
|
|
|
3 | Normal operation | Reserved |
|
|
|
4 | Normal operation | Test mode |
|
|
|
NOTE:
You should not change the
! CAUTION:
Do not plug the A/C adapters into the electrical outlets until instructed to do so in the following procedure.
Issue 1 June 1998