Lucent Technologies 1100 manual Installation

Page 61

Installation

!

CAUTION:

Connecting the Remote Module to the DEFINITY ECS can result in damage to the module. Prior to installation, check that you have the Switch Module by looking at the name on the top of the unit.

2.Connect the wiring of the DEFINITY analog circuit pack (the 8- port TN742 or the 16-port TN746) or a dedicated central office line (provided only with this connection) with the TELCO LINE jack of the Switch module at the on-premise location. See the DEFINITY® Communications System Generic 3, Installation for Single-Carrier Cabinets manual for complete instructions.

3.If you have not already done so while programming passwords, connect the Switch Module PHONE/SWITCH jack to the 2- wire, 24-port TN2224 circuit pack or 16-port TN2181 circuit pack on the DEFINITY ECS. See the DEFINITY® Communications System Generic 3, Installation for Single- Carrier Cabinets manual for complete instructions.

!

CAUTION:

Do not plug the line cord into the PHONE/SWITCH jack of the Switch Module. Damage to circuits may result.

4.Connect the AC adapter, provided with your system, to the Switch Module. Plug the adapter into a standard 120 VAC electrical outlet.

3-6Issue 1 June 1998

Image 61

Contents Definity Extender Federal Communications Commission Statement Industry Canada IC Interference Information Contents Introduction Connecting the Switch Module GL-1 Figures Tables Important Safety Instructions Viii Issue 1 June Customer Support Information Support Telephone Number Security of Your System Preventing Toll Fraud Lucent Technologies Fraud Intervention Lucent Technologies Limited Warranty FCC Notification Repair Information Installation and Operational Procedures Customer Support Information Customer Support Information Xvi Issue 1 June Intended Audience About This BookSecurity Alert Terms and ConventionsTypographical Conventions How to Use This BookProduct Safety Labels Call Related DocumentsToll Fraud Security How to Comment on This Document Feedback Form This Form MAY be Photocopied Introduction1 System Configuration System Operation ConfigurationSecurity Alert Equipment List Switch ModuleCustomer-Supplied Equipment Compatibility Options SpecificationsPage Switch Module Specifications Description Considerations 10Issue 1 June Password Considerations Configuration2Programming the Switch Module Page Enhanced Terminal Interface Configure System ExitTerminal Edit Line Configuring the COM RS-232D Port Configuration Stop Bits Issue 1 June 1998 Setting Parity Setting Data RateSetting Data Bit Show Settings Setting Stop BitsAdditional Modem Initialization Setting Passwords Security Alert Considerations Programming Passwords Procedure To check a password To disable a password Configuring Passwords OnlinePage Configuration Issue 1 June 1998 Installation3 Electrical Requirements Location RequirementsConnecting the Switch Module Wiring RequirementsSwitch Module Back Panel Installation ProcedureDIP Switch Configuration Installation Connections for Data Transmission Female Connector on Module Hardware Flow Control Installation 10Issue 1 June Troubleshooting4 Troubleshooting LED Sequences LED Power up Sequences LED Sequence Description LED Power up Verification Sequences LED Sequence Description Module is online to a Remote Module no Rgrg Error Messages Cause Action Error MessagesError Messages Cause Action No Display on Telephone at Remote Location Specific ProblemsNo Connection/No Answer Page Reporting a Faulty Switch Module Troubleshooting Issue 1 June 1998 Glossary GL-2Issue 1 June Issue 1 June 1998 GL-3 GL-4Issue 1 June Issue 1 June 1998 GL-5 Glossary GL-6Issue 1 June