Lucent Technologies 1100 manual Installation Procedure, Switch Module Back Panel

Page 59

Installation

■RS-232Dprovides for simultaneous RS-232D communication between equipment at the off-premise site and the on-premise site.

■The DIP switch under Option Switch is used for system configuration.

■The connection for the AC adapter is +12VDC.

Telco Line Phone/Switch

RS232

Option

+12VDC

Switch

Figure 3-1. Switch Module Back Panel

In addition to the back panel connections, a three-color light- emitting diode (LED) is visible through the top of each unit and provides information about the status of the equipment.

Installation Procedure

Installing the Switch Module involves wiring the module to the DEFINITY ECS and connecting the power cord. You will need the applicable wiring to connect the Switch Module to the DEFINITY ECS. See the DEFINITY® Communications System Generic 3, Installation for Single-Carrier Cabinets manual, document #555- 230-894, comcode #107595423, for complete installation requirements.

3-4Issue 1 June 1998

Image 59

Contents Definity Extender Federal Communications Commission Statement Industry Canada IC Interference Information Contents Introduction Connecting the Switch Module GL-1 Figures Tables Important Safety Instructions Viii Issue 1 June Customer Support Information Support Telephone Number Security of Your System Preventing Toll Fraud Lucent Technologies Fraud Intervention Lucent Technologies Limited Warranty FCC Notification Repair Information Installation and Operational Procedures Customer Support Information Customer Support Information Xvi Issue 1 June Intended Audience About This BookSecurity Alert Terms and ConventionsTypographical Conventions How to Use This BookProduct Safety Labels Call Related DocumentsToll Fraud Security How to Comment on This Document Feedback Form This Form MAY be Photocopied Introduction1 System Configuration System Operation ConfigurationSecurity Alert Customer-Supplied Equipment Switch ModuleEquipment List Compatibility Options SpecificationsPage Switch Module Specifications Description Considerations 10Issue 1 June Password Considerations Configuration2Programming the Switch Module Page Enhanced Terminal Interface Configure System ExitTerminal Edit Line Configuring the COM RS-232D Port Configuration Stop Bits Issue 1 June 1998 Setting Data Bit Setting Data RateSetting Parity Additional Modem Initialization Setting Stop BitsShow Settings Setting Passwords Security Alert Considerations Programming Passwords Procedure To check a password To disable a password Configuring Passwords OnlinePage Configuration Issue 1 June 1998 Installation3 Electrical Requirements Location RequirementsConnecting the Switch Module Wiring RequirementsSwitch Module Back Panel Installation ProcedureDIP Switch Configuration Installation Connections for Data Transmission Female Connector on Module Hardware Flow Control Installation 10Issue 1 June Troubleshooting4 Troubleshooting LED Sequences LED Power up Sequences LED Sequence Description LED Power up Verification Sequences LED Sequence Description Module is online to a Remote Module no Rgrg Error Messages Cause Action Error MessagesError Messages Cause Action No Connection/No Answer Specific ProblemsNo Display on Telephone at Remote Location Page Reporting a Faulty Switch Module Troubleshooting Issue 1 June 1998 Glossary GL-2Issue 1 June Issue 1 June 1998 GL-3 GL-4Issue 1 June Issue 1 June 1998 GL-5 Glossary GL-6Issue 1 June