Lucent Technologies 1100 manual FCC Notification Repair Information

Page 16

Customer Support Information

FCC Notification

and Repair Information

This equipment is registered with the FCC in accordance with Part 68 of its rules. In compliance with those rules, you are advised of the following:

Means of Connection. Connection of this equipment to the telephone network shall be through a standard network interface jack, USOC RJ11C. These USOCs must be ordered from your telephone company.

Party Lines and Coin Telephones. This equipment can not be used with party lines or coin telephone lines.

Notification to the Telephone Companies. Before connecting this equipment, you or your equipment supplier must notify your local telephone company’s business office of the following:

The telephone number(s) you will be using with this equipment.

The appropriate registration number and ringer equivalence number (REN). The REN for the DEFINITY Extender 1100 System is 2.

For each jack, the sequence in which lines are to be connected, the line types, the Facility Interface Code (FIC), and the Ringer Equivalence Number (REN) by position when applicable.

Issue 1 June 1998 xiii

Image 16
Contents Definity Extender Federal Communications Commission Statement Industry Canada IC Interference Information Contents Introduction Connecting the Switch Module GL-1 Figures Tables Important Safety Instructions Viii Issue 1 June Customer Support Information Support Telephone Number Security of Your System Preventing Toll Fraud Lucent Technologies Fraud Intervention Lucent Technologies Limited Warranty FCC Notification Repair Information Installation and Operational Procedures Customer Support Information Customer Support Information Xvi Issue 1 June About This Book Intended AudienceTerms and Conventions Security AlertHow to Use This Book Typographical ConventionsProduct Safety Labels Related Documents CallToll Fraud Security How to Comment on This Document Feedback Form This Form MAY be Photocopied Introduction1 System Operation Configuration System ConfigurationSecurity Alert Equipment List Switch ModuleCustomer-Supplied Equipment Compatibility Specifications OptionsPage Switch Module Specifications Description Considerations 10Issue 1 June Configuration2 Password ConsiderationsProgramming the Switch Module Page Configure System Exit Enhanced Terminal InterfaceTerminal Edit Line Configuring the COM RS-232D Port Configuration Stop Bits Issue 1 June 1998 Setting Parity Setting Data RateSetting Data Bit Show Settings Setting Stop BitsAdditional Modem Initialization Setting Passwords Security Alert Considerations Programming Passwords Procedure To check a password Configuring Passwords Online To disable a passwordPage Configuration Issue 1 June 1998 Installation3 Location Requirements Electrical RequirementsWiring Requirements Connecting the Switch ModuleInstallation Procedure Switch Module Back PanelDIP Switch Configuration Installation Connections for Data Transmission Female Connector on Module Hardware Flow Control Installation 10Issue 1 June Troubleshooting4 Troubleshooting LED Sequences LED Power up Sequences LED Sequence Description LED Power up Verification Sequences LED Sequence Description Module is online to a Remote Module no Rgrg Error Messages Error Messages Cause ActionError Messages Cause Action No Display on Telephone at Remote Location Specific ProblemsNo Connection/No Answer Page Reporting a Faulty Switch Module Troubleshooting Issue 1 June 1998 Glossary GL-2Issue 1 June Issue 1 June 1998 GL-3 GL-4Issue 1 June Issue 1 June 1998 GL-5 Glossary GL-6Issue 1 June