GarrettCom manual Eight-port SFF fiber modules 6K8-MTRJ, 6K8-MLC, 100Mb Fiber

Magnum 6K8-Series Industrial Field Switch Installation and User Guide (04/07)

feature which allows the Magnum 6K8 to monitor the internal power failure and controlled via hardware or software trap controls. The options for universal AC and 24V/-48V/125VDC-power options offer a widely accepted managed switch with high reliability.

2.2.2Eight-port SFF fiber modules (6K8-MTRJ, 6K8-MLC), 100Mb

fiber

1 3 5 7

ACT					ACT
F/H					F/H
ACT					ACT
F/H	LK	LK	LK	LK	F/H
ACT					ACT
F/H					F/H
ACT					ACT
	LK 2	4 LK	6LK	8LK
F/H					F/H

Fig.2.2.2:

SFF Fiber Port Modules,

6K8-MTRJ (to the left) and

6K8-MLC or -SLC (below)

In an eight-port SFF fiber port module, all of the fiber ports are of the same speed (100Mb), mode, and connector type. Models available with Small Form Factor (SFF) are multi-mode MT-RJ or LC-type connectors, and single-mode LC-type connectors.

The 100Mb fiber eight-port		1		3		5		7
modules for the Magnum 6K8-Series	AC									ACT
	F/H									F/H
normally are set (factory default) to	AC									ACT
										F/H
	F/H	LK			LK		LK		L
operate in full-duplex mode for best		2		4		6		8
	AC									ACT
	F/H									F/H
fiber distance and performance. Using	AC									ACT
	F/H	LK			LK	6	LK	8	L	F/H
the 6K-MNS software, the user may			2	4
select full- or half-duplex mode per-port through set-up of the software (See Magnum

6K-MNS Software Manual) for the flexibility to adapt to any FDX or HDX type of Fast Ethernet devices).

There are three LED’s per fiber port. The Link (LK) LED indicates “ready for operation” on that port when lit, the F/H LED indicates operation in full-duplex mode when ON (half-duplex when OFF), and the blinking ACT LED indicates receiving Activity on the port. A fiber cable must be connected into a SFF port and the Link (LK) indicator for that port must be ON (indicating there is a

www . GarrettCom . com

11