GarrettCom 6K8 manual PoE LEDs Summary

Page 63

Magnum 6K8-Series Industrial Field Switch

Installation and User Guide (04/07)

5.2.10New PoE (Power Pass-through), model P6KP8V-RJ45 (MDIX), 10/100Mb

8-port

 

 

 

 

6KP8-45RJ

 

 

 

 

The

8 Port@ 10/100Mb Copper ports

 

 

PoE RJ-45 ports

 

 

1

 

3

5

 

 

2

act similar to

 

10/10

 

 

 

 

LK/AC

 

1

 

 

 

 

 

 

 

 

 

F/ H

2

 

4

6

POE

 

 

 

 

10/10

 

 

 

 

regular RJ-45

 

 

 

 

 

LK/AC

 

 

 

F/H

 

 

 

 

POE

4

3

 

 

 

 

 

 

ports, except they

 

LK/ACT

 

 

1

2

 

10/10

 

 

have capability of

LINK

 

 

 

 

3

PoE

 

 

4

 

FULL/HALF

 

 

 

 

 

 

 

 

providing power

on each port to power up the PD devices, per the IEEE802.3af PoE standard. The Power Pass-through PoE modules are totally dependent upon the powerful -48VDC input power supply to support more RJ-45 (10/100) ports. Each port requires at least 15watts to power up the PoE PD devices. In this Fig. the top 8-RJ45 ports are enhanced with POE option The 8-RJ45 POE modules are also available with mix –n-match with fiber modules. Please check the ordering information Sec.1.2 for all the various P6K PoE modules option.

The LEDs on 6KP8-RJ45- PoE modules are slightly different compared to regular (non-PoE) RJ-45 modules as shown in Fig 2. When the PoE port is in use, the PoE LED is ON when connected properly to an 803.af compliant PD device on that port. When non-PoE devices are connected, the PoE LED is OFF. PoE does not affect operation of Ethernet data traffic.

LINK and ACTIVITY LEDS are combined on the PoE modules into one LED that is marked as LINK/ACT, as shown in the diagram.

PoE LEDs Summary

•For PoE devices, each RJ-45 PoE port supports only 802.3af complaint devices. The PoE LED is ON when the attached PD is drawing power from the port.

•For non-PoE devices connected, the PoE port will act as a normal RJ-45 port and the PoE LED is OFF. No power is being sent out from the port.

•The PoE ports in Magnum 6K’s with 48VDC power input act as a pass- through, so the 48VDC power source must be strong enough to provide power to the 6K switch and to all the 8 RJ-45 ports with PD devices connected (up to 15 watts per PoE port).

www. GarrettCom . com

58

Page 62 Page 64
Image 63
Page 62 Page 64
Contents Industrial Field Switch Trademarks Canadian Emission Contacting GarrettCom, IncTable of Contents InstallationIntroduction 14 6KM-BLNK TroubleshootingOverview Magnum LineMaximum 10 Mbps Ethernet Segment Lengths Technical SpecificationsPerformance Network Standards and Compliance, hardwareManagement Console connector Fiber Multi-mode connector types supportedFiber Single-mode connector types Alarm Relay ContactsAgency Approvals Magnum 6K8 DC Power Supply OptionsPer-port MDI or Mdix on RJ-45 MountingsConfiguration Options Ordering InformationMagnum 6K8 Port Modules GBIC1000Mb Transceiver options for Mangum 6K8-Series Introduction Inspecting the Package and Product Product Description Magnum 6K8-Series 6K8 1a Magnum 6K8-Series, Industrial Field Switch Www . GarrettCom . com Eight-port SFF fiber modules 6K8-MTRJ, 6K8-MLC, 100Mb Fiber Normally are set factory default toOperate in full-duplex mode for best Fiber distance and performance. UsingNegotiation is not disabled FDX/HDX LED is on to When lit. The 10/100 LED Indicates operation at 100MbSpeed when on and at 10 MB Speed when OFF when autoST or SC @RJ-45 + 2@ 100MbFour-Port 10 MB and 100Mb mm Fiber ST Modules Gigabit 1000Mbps port modules 7a GBPM-2OTX Two Gigabit port option Packet Prioritization, 802.1p QOS Gbic DescriptionManaged Network Software MNS-6K for Magnum 6K8-Series Frame Buffering and Flow ControlWww . GarrettCom . com „ Large selection of built-in fiber options at 10/100/1000Mb Applications Interne Control Center Scada Mounting Instructions Copper Locating Magnum 6K8-Series SwitchesConnecting Ethernet Media Ieee Standard Media Type Max. Distance Port Module FiberConnecting Fiber Optic ST-type, twist-lock Connecting Fiber Optic SC-type, Snap-InConnecting Single-Mode Fiber Optic 100BASE-TX Media Ieee StandardWww . GarrettCom . com DIN-Rail Mounting Quantity Description Din-Rail kit Installation proceduresWww . GarrettCom . com Mounting Dimensions for 6K8 with metal brackets Powering the Magnum 6K8-Series Industrial Field Switch Www . GarrettCom . com Preparation for Installing and Removing 6KPMVs from 6K8’s 6K8-Series Port Module 6KPMV Installation1a Removing the Top panel from the Chassis base of the unit Remove Chassis CoverInstalling 6KPM Cards in the Magnum 6K8-Series 2a a Magnum 6K8 unit with main board motherboard only2b Granddaughter Board shown separately Female latch connector 2h sliding in the top cover onto the chassis base track Removing 6KPM Cards Retaining screws shown by arrows Remove 6KPM CardRemoving a 6KPM Card Enlarged view of Magnum 6K8-Series Console Port area Connecting a Management Console Terminal to Magnum 6K8Switching Functionality DB-9 Console port connector1 RS-232 DB-9 Console Com port Serial port pin assignments Dual LEDs Status on TOP and Front of the 6K8-Series unit Filtering and ForwardingAddress Learning Auto-Cross Mdix and Auto-negotiation, for RJ-45 ports Flow-control, Ieee 802.3x Standard Www . GarrettCom . com ’cvr 6KP4V6KPMV Module Description Introduction Magnum 6K8 Industrial Field Switch Port ModulesMagnum 6K8-Series Managed Segments. When installed in aSwitch, the copper port Dual speed copper ports1b 6KP4-F10ST, 4@10Mb multi-mode FX-ST twist lock Module Activity ACT, Link LK, Mode 100Mbps fiber opticMagnum 6KP6 Transceivers all in one module. This2@100Mbps single Mode FX-SC-type, snap Connector 6KP6-RJSSC 4@10/100Mbps RJ-45 Ports Port@ 100Mbps Multi-Mode Fiber port 5 6KP8-MTRJ, 8 @100Mb multi-mode FX, Mtrj Small-Form-factorMagnum 6KP8-45MT Module is a combo module with Port multi-mode fiber LC connector 10/100Mb 8-Port 9 6KP8-RJ45 Twisted PairPoE LEDs Summary 45-2MT eight ports Module is a 100Mb SC GBIC-SXSC Gigabit fiber 1000Mb, multi-mode SC Connector12a GBIC-LXSC Gigabit fiber 1000Mb, multi-mode SC Connector Standard 1@ 1000Mb Fiber SC + 2@GBPM-2OTX Two Gigabit option Before Calling for Assistance When Calling for Assistance No Problem Found Appendix B Internal DC Power Supply Options B3.0 Applications for DC Powered Ethernet Switches B2.0 -48VDC, 24VDC and 125VDC POWER, Theory of OperationB4.0 6K8-SERIES, -48V, 24, 125 or 5VDC Installation B7.0 Troubleshooting C4.0 Features and Benefits of the DUAL-SOURCE Design C5.1 UL Requirements External Terminal Block on a Magnum 6K8 -48VDCExample Magnum 6K8 -24VDC C6.0 Ordering Information Optional
Related manuals
Manual 69 pages 29.41 Kb
Top Page Image Contents