Magnum | Installation and User Guide (04/07) |
Figure 3.6.1d: Removing PM screens Plate
Once opened all the four retaining screws the front cover can be removed easily as shown in Fig 3.6.1d. (To the left).
Carefully remove the PM screen plate using finger or small screwdriver to come out easily as shown in Fig 3.6.1d on the right. Just be careful on the LEDs placed both side and hold
the faceplate tightly. There are no screws used on holding the screen faceplate.
Figure 3.6.1d: Removing Face Plate
3.6.2Installing 6KPM Cards in the Magnum 6K8-Series
Only one
Step 1. Remove top chassis cover. See procedure in Section 3.6.1 above.
Fig 3.6.2a A Magnum 6K8 unit with main board (motherboard) only
Step 2. Place Granddaughter board (as shown in fig. 3.6.2b) on the chassis built in stand off (female) provided at the front of the
Fig 3.6.2b Granddaughter Board shown separately
on the chassis, as shown in Figure below 3.6.2c, screw down tightly with the three 5/16 stand off (male) on the top of the Granddaughter board. The three 5/16 stand off has been used to place the daughter board on the top of the granddaughter board and a latch
www . GarrettCom . com
38