Magnum
press slowly and firmly with two fingers (as shown below in Fig. 3.6.2f) on the top of the latching connectors until the connectors latched up securely.
Figure 3.6.2f:
Securely latching up 6KPMV Cards into a Magnum
down the daughter board with 6 #440 screws, so that it holds the daughter board securely. The figure on the left shows the top view of successfully installed 6KPMV cards inside and the Power Led (pin J5) and Power supply cable (pin DSSV) connected to the board pins as shown in Fig 3.6.2g with arrows.
Fig. 3.6.2g Top View: 6KPM Module installed and
insight for connecting two wires to the right pins
Step 7. Once the installation of granddaughter and daughter modules is done, the front panel screen plates of 6KPMV need to be placed on the face of the module securely and carefully. Now screw down properly the faceplate with 4 screws to complete the installation
process for port module. The front panel screen plate does not need any screws to hold on port module, but need to place tightly and carefully while placing on LEDs.
Fig. 3.6.2h sliding in the top cover onto the chassis base track
Step 8. Once 6KPMV card have been
installed (including faceplate and screen plate), the chassis cover should be replaced. Make
sure the chassis top cover is aligned properly to the base before securely sliding the chassis base track inside the top cover properly as shown in Fig. 3.6.2h.
www . GarrettCom . com
40