GarrettCom 6K8 Fiber Multi-mode connector types supported, Fiber Single-mode connector types

Page 8

Magnum 6K8-Series Industrial Field Switch

Installation and User Guide (04/07)

Fiber Multi-mode connector types supported:

Fiber Port, ST-type (twist-lock): Fiber multi-mode, 10Mb 10BASE-FL

Fiber Port, MTRJ-type (plug-in): SFF Fiber multi-mode100BASE-FX

Fiber Port, SC-type (snap-in): Fiber optic multi-mode, 100BASE-FX

Fiber Port, ST-type (twist-lock): Fiber optic m.-mode, 100BASE-FX

Fiber Port, 1000BASE-FX, GBIC modules

Fiber Single-mode connector types:

Fiber Port, SC-type: Fiber optic single-mode, 100BASE-FX

Fiber Port, LC-type Fiber optic SFF single-mode, 100BASE-FX

Fiber Port, 1000BASE-FX, GBIC modules

LEDs: Per Port (one set at the port, one set on rear top) LK: Steady ON when media link is operational ACT: ON with receiver port activity FDX/HDX: ON = Full-Duplex Mode

OFF = Half-Duplex Mode

100/10: ON = 100Mbps speed OFF = 10 Mbps

Operating Environment

Ambient Temperature:

-40°to 140° F (-40°to 60°C) for UL60950 and Component Parts rating -60°to 205° F (-50°to 95°C) for IEC 60068 Type Test short-term rating

Storage Temperature: -60°to 210°F (-50°to 100°C)

Ambient Relative Humidity: 5% to 95% (non-condensing)

Altitude: -200 to 13,000 ft. (-60 to 4000m)

Conformal Coating (humidity protection) option: Request quote

Alarm Relay Contacts

One NC indicating internal power, one NC software controllable

Packaging

Enclosure: Rugged High strength sheet metal.

Dimensions: 9.8 in. H x 5.90 in. W x 3.70 in. D 24.9 cm H x 15.0 cm W x 9.4 cm D

Cooling method: Convection, fully –enclosed elongated dual-cavity case used as heat-sink. designed for vertical mounting, no fans

Weight: 2.1 lbs. (0.95 kg)

Management Console connector

DB-9 for RS-232 “null-modem” cable (sometimes called an X-modem cable)

Power Supply (Internal)

AC Power Connector: IEC-type, male recessed at rear of chassis,

Input Voltage: 100 to 240 VAC (auto-ranging)

Input Frequency: 47 to 63 Hz (auto-ranging) Power Consumption:

25 watts typical (for a fully loaded fiber model)

15 watts typical (for a 8-port copper only model)

www . GarrettCom . com

3

Image 8

Contents Industrial Field Switch Trademarks Contacting GarrettCom, Inc Canadian EmissionIntroduction Table of ContentsInstallation Troubleshooting 14 6KM-BLNKMagnum Line OverviewTechnical Specifications PerformanceNetwork Standards and Compliance, hardware Maximum 10 Mbps Ethernet Segment LengthsFiber Multi-mode connector types supported Fiber Single-mode connector typesAlarm Relay Contacts Management Console connectorDC Power Supply Options Per-port MDI or Mdix on RJ-45Mountings Agency Approvals Magnum 6K8Magnum 6K8 Port Modules Configuration OptionsOrdering Information GBIC1000Mb Transceiver options for Mangum 6K8-Series Introduction Inspecting the Package and Product Product Description Magnum 6K8-Series 6K8 1a Magnum 6K8-Series, Industrial Field Switch Www . GarrettCom . com Normally are set factory default to Operate in full-duplex mode for bestFiber distance and performance. Using Eight-port SFF fiber modules 6K8-MTRJ, 6K8-MLC, 100Mb FiberWhen lit. The 10/100 LED Indicates operation at 100Mb Speed when on and at 10 MBSpeed when OFF when auto Negotiation is not disabled FDX/HDX LED is on to@RJ-45 + 2@ 100Mb ST or SCFour-Port 10 MB and 100Mb mm Fiber ST Modules Gigabit 1000Mbps port modules 7a GBPM-2OTX Two Gigabit port option Gbic Description Packet Prioritization, 802.1p QOSFrame Buffering and Flow Control Managed Network Software MNS-6K for Magnum 6K8-SeriesWww . GarrettCom . com „ Large selection of built-in fiber options at 10/100/1000Mb Applications Interne Control Center Scada Mounting Instructions Locating Magnum 6K8-Series Switches Connecting Ethernet MediaIeee Standard Media Type Max. Distance Port Module Fiber CopperConnecting Single-Mode Fiber Optic Connecting Fiber Optic ST-type, twist-lockConnecting Fiber Optic SC-type, Snap-In Media Ieee Standard 100BASE-TXWww . GarrettCom . com DIN-Rail Mounting Din-Rail kit Installation procedures Quantity DescriptionWww . GarrettCom . com Mounting Dimensions for 6K8 with metal brackets Powering the Magnum 6K8-Series Industrial Field Switch Www . GarrettCom . com 6K8-Series Port Module 6KPMV Installation Preparation for Installing and Removing 6KPMVs from 6K8’sRemove Chassis Cover 1a Removing the Top panel from the Chassis base of the unit2b Granddaughter Board shown separately Installing 6KPM Cards in the Magnum 6K8-Series2a a Magnum 6K8 unit with main board motherboard only Female latch connector 2h sliding in the top cover onto the chassis base track Removing a 6KPM Card Removing 6KPM CardsRetaining screws shown by arrows Remove 6KPM Card Connecting a Management Console Terminal to Magnum 6K8 Enlarged view of Magnum 6K8-Series Console Port area1 RS-232 DB-9 Console Com port Serial port pin assignments Switching FunctionalityDB-9 Console port connector Address Learning Dual LEDs Status on TOP and Front of the 6K8-Series unitFiltering and Forwarding Auto-Cross Mdix and Auto-negotiation, for RJ-45 ports Flow-control, Ieee 802.3x Standard Www . GarrettCom . com 6KP4V ’cvrIntroduction Magnum 6K8 Industrial Field Switch Port Modules 6KPMV Module DescriptionSegments. When installed in a Switch, the copper portDual speed copper ports Magnum 6K8-Series Managed1b 6KP4-F10ST, 4@10Mb multi-mode FX-ST twist lock Module Mode 100Mbps fiber optic Magnum 6KP6Transceivers all in one module. This Activity ACT, Link LK,10/100Mbps RJ-45 Ports 2@100Mbps single Mode FX-SC-type, snap Connector6KP6-RJSSC 4@ 5 6KP8-MTRJ, 8 @100Mb multi-mode FX, Mtrj Small-Form-factor Port@ 100Mbps Multi-Mode Fiber portMagnum 6KP8-45MT Module is a combo module with Port multi-mode fiber LC connector 9 6KP8-RJ45 Twisted Pair 10/100Mb 8-PortPoE LEDs Summary 45-2MT eight ports Module is a GBIC-SXSC Gigabit fiber 1000Mb, multi-mode SC Connector 12a GBIC-LXSC Gigabit fiber 1000Mb, multi-mode SC ConnectorStandard 1@ 1000Mb Fiber SC + 2@ 100Mb SCGBPM-2OTX Two Gigabit option Before Calling for Assistance When Calling for Assistance No Problem Found Appendix B Internal DC Power Supply Options B2.0 -48VDC, 24VDC and 125VDC POWER, Theory of Operation B3.0 Applications for DC Powered Ethernet SwitchesB4.0 6K8-SERIES, -48V, 24, 125 or 5VDC Installation B7.0 Troubleshooting C4.0 Features and Benefits of the DUAL-SOURCE Design External Terminal Block on a Magnum 6K8 -48VDC C5.1 UL RequirementsC6.0 Ordering Information Optional Example Magnum 6K8 -24VDC

Related manuals

Manual 69 pages 29.41 Kb