GarrettCom 6K8 manual Removing 6KPM Cards, Retaining screws shown by arrows Remove 6KPM Card

Magnum 6K8-Series Industrial Field Switch Installation and User Guide (04/07)

3.6.3Removing 6KPM Cards

To properly remove a 6KPM card from the 6K8-Series Industrial Field Switch, follow the 3 steps below.

Step 1. Remove chassis cover See procedures in Section 3.6.1 above.

Caution: Be sure the power cord is unplugged.

Step 2. Remove retaining screws placed on top of the 6KPMV and Face Plate

Each 6KPMV module is secured with nine retaining screws #440x3/8. These screws are used to secure a 6KPM card in position (see Figure 3.6.3a). Remove the 9 screws to take off the daughter module and thereafter three standoffs underneath holding the Granddaughter board with the chassis.

Figure 3.6.3a: 8

retaining screws shown by arrows

Step 3. Remove 6KPM

Card

Carefully and gently pull out the daughter board from the latching connectors,

using both hands, gripping the board near the latch-up connectors as shown in Fig. 3.6.3b

Figure 3.6.3b:

Removing a 6KPM Card

www . GarrettCom . com

41