Detailed Explanation of Each Function Code
F 0 0 Data Protection
The set data can be locked so that it will not be changed by mistake.
0Data change possible
1Data change not possible
To change data simultaneously press the STOP key and either the UP/DOWN key.
F 0 1 Frequency Command
Either of the following two frequency setting methods can be selected.
0Keypad panel setting (UP/DOWN keys)
1Analog input (setting by volume control, 0
F 0 2 Operation Command
Either of the following two control methods can be selected.
0Keypad panel operation (RUN/STOP keys)
1External signal operation (FWD/REV keys)
F 0 3 Maximum Frequency
Sets the maximum value for the output frequency
50
1 2 0
Multipurpose motors and other motors which are designed to operate at low speed can be damaged if operated at high frequency. Be sure to set the frequency to match the characteristics of the motor.
F 0 4 Base Frequency
V
1 Maximum frequency
Sets the base frequency (the frequency which is the divergent point of the specified torque characteristics and the specified output characteristics).
5 0 Frequency can be set in increments of 1 Hz within a range of 50 to 120 Hz
1 2 0
—Set to match the characteristics of the motor.
—Although the base frequency may exceed the maximum
| frequency, in that case the voltage will be decreased accordingly. | V |
| |||||
|
|
|
| 1 | Base | |||
|
|
|
|
|
|
| ||
|
|
|
|
|
|
| ||
F | 0 | 5 | Acceleration Time |
|
|
|
| frequency |
F | 0 | 6 | Deceleration Time |
|
|
|
|
|
| 0. | 0 | The time required to reach the maximum output frequency can be set within a range of |
| ||||
6 | 0. | 0 | 0.0s to 60s (in increments of 0.1s). |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Note: 0.0s setting is taken for 0.01s for acceleration and 0.1s for deceleration.
25