CAUTION:
Check that the phase and voltage of the AC power supply being connected matches the input phase and rated input voltage of the drive. Using an improper power supply may cause injury or damage to the equipment.
Do not connect AC power to the output termi- nals (U, V, W) otherwise injury may result.
The drive, motor and wiring produce electromag- netic noise during operation. Make sure that this does not interfere with the operation of sensors or other equipment nearby, otherwise accidents may result.
OPERATION
WARNING:
ELECTRIC SHOCK HAZARD
Always install the drive cover before turning on the power supply. In addition, do not remove the drive cover while the power is on. Failure to observe these precautions may result in electric shocks.
Do not operate any of the switches with wet hands, otherwise electric shocks may result.
WARNING:
FIRE AND PERSONAL INJURY HAZARD
If the retry function has been activated and a trip occurs, the drive will restart automatically de- pending on the cause of the trip. Make sure that the system is set up properly so that there will be no danger to personnel when the drive starts.
The STOP key is only effective when keypad panel operation has been selected in the func- tion settings. A separate switch should be installed for emergency stopping purposes.
If an alarm reset is carried out while a run signal (FWD/REV) is being input, the drive will suddenly restart. Always check that the run signal is not being input before carrying out the alarm reset, otherwise accidents may occur.
Never touch the drive terminals while the power is fed to the drive, regardless of whether the drive is running or not.
CAUTION:
Do not touch the cooling fins, as they become hot during drive operation.
Because it is relatively easy to set the drive to high speed operation, be sure to check the capacity of the motor and the equipment being operated before changing the drive function setting.
The drive braking function cannot be substituted for mechanical means. Attempting to do so may result in injury.
MAINTENANCE, INSPECTION AND PART REPLACEMENT
WARNING:
ELECTRIC SHOCK HAZARD
Wait at least five minutes after turning off the power before carrying out inspection. Check that the charge indication lamp has gone out. Do not touch the drive parts if the lamp is still lit, other- wise electric shocks may result.
Maintenance, inspection and parts replacement should only be carried out by suitably qualified personnel. Remove any metallic accessories such as watches and rings before starting work, and use only properly insulated tools, otherwise electric shocks may result.
DISPOSAL
CAUTION
Disposal of the drive should be entrusted to a
PACKING
CAUTION
Do not stand or sit on the drive as injury may result.
The number of packing cartons that can be stacked together is printed on the packing container. Do not stack the containers any higher than this or injury may result.
5