GE FVR-C9S-7UX instruction manual Specifications, Supply voltage 3%

FVR-C9S-7UX

4. Specifications

Type (FVR _ _ _ C9S-7UX)				F12		F25	F50	001	002
Applicable motor output1			[Hp]	1/8		1/4	1/2	1	2
	Rated capacity2		[kVA]	0.27		0.5	0.87	1.5	2.7
	Voltage		[V]	Three-phase 220-240V 50/60 Hz (Output voltage is proportional
				to input voltage)
Output Rating	Rated current		[A]	0.66		1.2	2.1	3.7	6.4
	Overload current rating			150% 1 min.
	Rated frequency		[Hz]	50/60 Hz
	Phase, voltage, frequency			Single-phase 220-240V 50/60 Hz
	Allowable variation in			Voltage: =10 - 15% Frequency: 15% (Imbalance in power
Input power	voltage/frequency			supply voltage: 3%)
supply	Instantaneous voltage drop			Drive is kept running if voltage is 165V or more. If voltage drops
	withstanding capacity			more than 165V from rated voltage, drive is run for 15ms.3
	Required power supply		[kVA]	0.3		0.6	1.0	1.7	3.1
	capacity
	Adjustment	Max. freq.4	[Hz]	50-120 Hz Setting variable (in increments of 1 Hz)
		Base freq.	[Hz]	50-120 Hz Setting variable (in increments of 1 Hz)
	Starting freq.		[Hz]	1-6 Hz Setting variable (in increments of 1 Hz)
Output	Accuracy			Analog setting: ±1.0% of max. frequency (25±10°C)
frequency				Digital setting: ±0.01% of max. frequency (-10 - +50°C)
	Setting resolution			Analog setting:1/255 of max. frequency
					(ex. 0.25 Hz / 60 Hz, 0.5 Hz / 120 Hz)
				Digital Setting: 0.1 Hz (99.9 Hz max) 1 Hz (100-120 Hz)
	Control method			Sine wave PWM control
				(Extremely low noise by high frequency carrier)
Control	Operation			Keypad operation:			Operation control by RUN/STOP keys
				Terminal strip:			Forward command. Reverse command.
							Coast-to-stop command. Reset.
							External alarm.
1) "Applicable motor" indicates a standard 4-pole motor.									C92-7-13

2)"Rated capacity" indicates a capacity at 240V rating.

3)This applies to the case where momentary power failure occurs under such conditions that rated voltage is inputted and load factor is 85%.

4)Shows the case where an applicable motor equipped with an AC reactor (option) on the input side is used.

8