GE FVR-C9S-7UX instruction manual Part Names

FVR-C9S-7UX

1. Type

Drive Series

F V R F 2 5 C 9 S 7 U X

Power Series: 200V UX Series Applicable motor output (Hp)

3. Warning and Caution

Improper wiring will result in damage to, and failure of the unit. Please carefully note the items listed below, and use the unit as indi- cated.

2.Phase: 1AC - Single-phase

3.Voltage range: 220V - 240V AC200V Series

4.Frequency: 50/60Hz

5.Rated output capacity

6.Rated output current

7.Output frequency range: 1- 120 Hz

8.Serial No.

2. Part Names

4

2

PRG	RUN
RESET
FUNC	STOP
DATA

FVR-C9S

3

1

WARNING AND CAUTION

1.	Do not connect the power supply to
	voltage that exceeds the standard speci-
	fication voltage with permissible fluctua-
	tion. (Permissible voltage: AC220V -
	240V)
2.	Do not connect power supply to the drive
	output terminals (U, V, W). Connect
	power supply only to the power terminals
	(L1, L2)
3.	Whenever removing the drive cover,
	always switch off the power supply. Do
	not switch on the power supply to the
	drive with the drive cover removed.
4.	Do not touch the live part until the CRG
	lamp located above the main circuit
	terminals goes out.
5.	Avoid using a magnetic contactor (ON/
	OFF) installed in the line side of the drive
	for RUN and STOP. Use the FWD-CM
	(forward) and REV-CM (reverse) terminals
	for RUN and STOP.
6.	Do not connect a power factor correcting
	capacitor to the output side of the drive.
7.	Do not perform a megger test between
	the drive terminals or on the control

CLOSED

1.Drive Cover

2.Keypad Panel

3.Frequency Setting VR

4.Mounting Screw Holes

5.Drive Cover Screw

OPEN

4

5

circuit terminals.

7