GE FVR-C9S-7UX instruction manual Line

FVR-C9S-7UX

6)It is important that all lead length are kept as short as possible and that incoming mains and outgoing motor cables are kept well separated.

7)Segregate power cables from control wiring as possible as you can, and avoid parallel cable runs to minimize “noise cou- pling”. Wherever runs of power and control cable must cross, try to achieve this at right angles.

8)FVR drives should be installed, and are designed to operate, within an electrically shielded metal enclosure.

The RFI filters range are designed especially for the FVR drive and help to ensure EMC compliance of machinery an installations using the drives. The drives may be mounted on top of the filter using the integral fixing positions, the intention being that valuable space inside wiring cabinets may be saved. (Refer to Fig. 1 and Table 1)

Mains input terminals

Earth Stud

L N

LINE

Drive fixing

positionsLOAD

L’ N’

Earth Stud

Load terminals to drive input

X

W

Table 1 RFI Filter Dimensions Conforms to EN55011 Class B

Y

H

Fig. 1 RFI Filters

L

Filter	Applied	Rated	Max Rated	Dimensions inches			Drive	Sub
Part No.	Drive	Current	Voltage	L x W x H	X	Y	Fixings	Filters
EFL-0.2C9-7	FVRF12C9S-7UX	3A		6.69 x 3.35 x 1.38	1.97	6.1	M4 0.16	Ferrite
	FVRF25C9S-7UX						x0.63 (2pcs.)	OC1x (1 pcs.)
EFL-0.75C9-7	FVRF50C9S-7UX	10A	1-Phase	6.69 x 3.35 x 1.38	1.97	6.10	M4 0.16
	FVR001C9S-7UX		240 VAC				x0.63 (2 pcs.)
EFL-2.2C9-7	FVR002C9S-7UX	16A		7.09 x 4.53 x 1.38	3.50	6.50	M4 0.16	Ferrite
							x0.63 (4 pcs.)	OC2x (1 pcs.)

7-'006

38