GE FVR-C9S-7UX instruction manual Gain for Frequency Setting Signal, DC Brake Braking Time

100%

				FVR-C9S-7UX
		Restart After Momentary Power Failure
F 1 0
It is possible to select whether or not to restart operation when power supply is resumed after
momentary power failure.
	0	Inactive	While stopped:		Stopped condition is maintained even after power supply
					has been restored.
			While running: After power supply has been restored. LU is lit and an alarm
					is outputted.
	1	Active	Operation is restarted in 0.5s after power supply has been restored.
			(When drive is stopped, it is maintained in the stopped condition even after
			power supply has been restored).
			This is valid only if power supply is restored while LU is lit. The length of
			time that LU will remain lit after a power failure occurs is as follows.
			Drive Model		F12	F25	F50	001	002
			Time(s)		0.7	0.7	1.4	1.4	4.0

F 1 1 Gain for Frequency Setting Signal

Outputs a frequency which is a proportional ratio of the analog frequency setting. Selects an analog input signal level when F O 1 is _ _ 1.

0 Maximum frequency is outputted at 10V

1 Maximum frequency is outputted at 5V		setting
	When used together with the frequency setting bias,
	this frequency setting gain takes priority, and the
	bias applied to the frequency after the gain has
		Frequency
	been applied.

1

0

5V 10V Analog input

F 1 2 DC Brake

The current level of DC brake can be set.

Taking the rated current of the drive as 100%, this current level can be set in increments of 1%.

F 1 3 DC Brake (Braking Time)

The DC braking time can be set.

0.0Inactive

0.1- 30.0 Braking time can be set within a

range of 0.1 to 30s (in increments of 0.1s)

Output	Output
frequency	voltage
3 Hz
	Time	1 DC braking

28