Introduction
INTRODUCTION
The DN-3000 is an intelligent, multiple-function DeviceNet Data Transfer Unit designed for use within the harsh industrial environment.
Using the DN-3000 Configuration Editor Software program, the DN-3000 can be programmed to run either of the two (2) following application types:
1)DEVICENET TO PLCS OR DEVICES Allows a DeviceNet Host to read or write data registers in one or more PLCs or Devices that use the same protocol. One of the DN-3000’s three ports can be used as a pass-through port in which all messages received are simply passed through to one of the connected PLCs/Devices (if supported for that PLC/Device protocol), allowing PLC programming software, a third party’s intelligent (MMI) Man-Machine Interface terminal or a SCADA software program to be “connected” to the same port on the PLCs/Devices used by the DN-3000.
2)DEVICENET TO MOTOR DRIVES Allows a DeviceNet Host to control and/or monitor parameters in up to 32 Motor Drives.
This manual is presented in two sections. Each section deals with the configuration requirements for each of the above applications: DeviceNet to PLCs and DeviceNet to Motor Drives.
Please note that the application type is selected when a new project is created using the DN-3000 configuration software and may not be changed after the project is created.
1
