Enterasys Networks RBTSA-AB, RBTSA-AA manual Unpacking, Ethernet Adapter

Page 17

2	INSTALLING THE ETHERNET
	INSTALLING THE ETHERNET
	ADAPTER

This chapter contains the information you need to install and set up the

Ethernet Adapter. It covers the following topics:

	■ Unpacking the Ethernet Adapter
	■	Observing Safety Precautions
	■ Deciding Where to Place the Ethernet Adapter
	■ Connecting the Ethernet Adapter
	■ Checking the LED Indicators
	■ Attaching An External Antenna
	■ Determining if you Need to Configure the Ethernet Adapter
	■ Using the Enterasys Networks Installation CD

Unpacking the	Make sure that you have the following items, which are included with the
Ethernet Adapter	Ethernet Adapter:
	■ Power adapter and power cord.
	■ Standard Category 5 unshielded twisted pair (UTP) Ethernet cable.
	■ Rubber feet (four; used for a flat-surface installation).
	■ Enterasys Networks Installation CD.
	For wall-mounting installations, you need the following items, which
	are not included with the Ethernet Adapter:
	■	Mounting screws.

■ Plastic anchors (for drywall mounting).

Image 17

Contents RoamAbout Page Contents Obtaining Support for Your Enterasys Networks Product END User License Agreement Regulatory Information Page About this Guide List conventions that are used throughout this guide ConventionsConventions Documentation Accessing OnlineRelated Product Registration Support About this Guide Introduction 802.11g 802.11aPlanning ConfigurationNetwork Wireless Infrastructure Network ConfigurationsExample Operating systems, and network printers, as shown in FigureEthernet Adapter UnpackingEthernet Adapter Deciding Where to Place the Ethernet Adapter Place the Ethernet Adapter onto the wall, as shown in Figure To wall-mount the Ethernet AdapterConnect the power ConnectingInstalling the Ethernet Adapter Connecting to a Hub As follows IndicatorsChecking the LED LED Descriptions Attaching An Need to ConfigureExternal Antenna Determining if youNetworks without a Dhcp Server Shows the Ethernet Adapter configuration factory defaults Ethernet Adapter Default SettingsUsing the Enterasys Networks Installation CD Installing the Ethernet Adapter Configuring the Ethernet Configuring the Ethernet Adapter Click Configure Button Description Configure the Ethernet Adapter through your Web browser UsingManagement SystemClearing Applying System Configuration Settings System Properties Setting Description Wireless Network Select Specify the Wireless LAN Service Area to allow External and one internal antenna- this setting Set the Data Preamble 40/64-bit Shared Key WEP No Security Open System104/128-bit Shared Key 128/152-bit Shared KeyTkip Radius Authentication Server Settings Enables or disables Snmp Using the Configuration Management System About Uart Configuring Operation ModeConfiguring Network Serial Port Settings Configuring Uart Settings0x34 0x31 0x33 0x39 Factory Defaults Applying SettingsUsing FTP default To restore the settings through softwareClick Restore Using Http Using TftpUnder Tools, click Backup Wireless Ethernet Adapter For details Summary Click Refresh to update the informationFollowing table ProblemsDiagnosing Troubleshooting SymptomSolutions Disconnecting the To disconnect the Ethernet AdapterSoftware UninstallingUpgrading Ethernet Adapter FirmwareGetting Help Enterasys Networks using one of the following methodsPage END User License Agreement Page Regulatory Information MANUFACTURER’S Declaration of Conformity Canada Industry Canada IC Europe EU Declaration of Conformity Bipt 108, 112, 116