Enterasys Networks RBTSA-AA, RBTSA-AB To restore the settings through software, Click Restore

Page 52

46CHAPTER 3: CONFIGURING THE ETHERNET ADAPTER

To restore the settings through software:

1Under Tools, click Restore Factory Defaults.

2Click Restore.

If the Ethernet Adapter was using an IP address setting other than the default, restoring the factory defaults will change the IP address. If you want to continue configuring the Ethernet Adapter, do the following:

1Close your browser.

2Return to the Enterasys Networks Wireless Infrastructure Device Manager and click Refresh.

3Select the device and click Configure to start a new configuration session.

Upgrading the You can download firmware updates or updates to the Configuration System Management System from the Enterasys Networks Web site and install

these on the Ethernet Adapter.

Options for upgrading the system include using a Trivial File Transfer Protocol (TFTP) server or File Transfer Protocol (FTP) server. The Ethernet Adapter acts as a TFTP or FTP client to receive the download. Alternatively, you an use the HTTP option and upload the firmware from a downloaded file placed on your computer.

Using FTP (default)

The general instructions for installing the upgrade using FTP are:

1Launch the Configuration Management System.

2Under Tools, click Upgrade System.

3Select FTP.

4Enter the IP address of the FTP server where the upgrade files are located.

5Enter the user name, password, path and filename in the appropriate fields.

6Click Upgrade.

Image 52

Contents RoamAbout Page Contents Obtaining Support for Your Enterasys Networks Product END User License Agreement Regulatory Information Page About this Guide Conventions List conventions that are used throughout this guideConventions Related Accessing OnlineDocumentation Product Registration Support About this Guide Introduction 802.11a 802.11gNetwork ConfigurationPlanning Configurations Wireless Infrastructure NetworkExample Operating systems, and network printers, as shown in FigureUnpacking Ethernet AdapterEthernet Adapter Deciding Where to Place the Ethernet Adapter To wall-mount the Ethernet Adapter Place the Ethernet Adapter onto the wall, as shown in FigureConnecting Connect the powerInstalling the Ethernet Adapter Connecting to a Hub Checking the LED IndicatorsAs follows LED Descriptions Need to Configure Attaching AnExternal Antenna Determining if youNetworks without a Dhcp Server Ethernet Adapter Default Settings Shows the Ethernet Adapter configuration factory defaultsUsing the Enterasys Networks Installation CD Installing the Ethernet Adapter Configuring the Ethernet Configuring the Ethernet Adapter Click Configure Button Description Using Configure the Ethernet Adapter through your Web browserManagement SystemClearing Applying System Configuration Settings System Properties Setting Description Wireless Network Select Specify the Wireless LAN Service Area to allow External and one internal antenna- this setting Set the Data Preamble No Security Open System 40/64-bit Shared Key WEP104/128-bit Shared Key 128/152-bit Shared KeyTkip Radius Authentication Server Settings Enables or disables Snmp Using the Configuration Management System Configuring Operation Mode About UartConfiguring Uart Settings Configuring Network Serial Port Settings0x34 0x31 0x33 0x39 Applying Settings Factory DefaultsClick Restore To restore the settings through softwareUsing FTP default Using Tftp Using HttpUnder Tools, click Backup Wireless Ethernet Adapter For details Click Refresh to update the information SummaryDiagnosing ProblemsFollowing table Troubleshooting Disconnecting the To disconnect the Ethernet Adapter SymptomSolutionsUninstalling SoftwareUpgrading Ethernet Adapter FirmwareEnterasys Networks using one of the following methods Getting HelpPage END User License Agreement Page Regulatory Information MANUFACTURER’S Declaration of Conformity Canada Industry Canada IC Europe EU Declaration of Conformity Bipt 108, 112, 116