Enterasys Networks RBTSA-AA manual Uninstalling, Software, Upgrading Ethernet, Adapter Firmware

Page 60

54CHAPTER 4: TROUBLESHOOTING

Uninstalling

If you want to uninstall the Enterasys Networks 11a/b/g Wireless Ethernet

Software and

Adapter software and documentation, you can either use the standard

Documentation

operating system procedure for removing programs or use the following

 

shortcut:

 

1 For WIN2000: select Start>Settings>Control Panel>Add/Remove

 

Programs Click "Change/Remove" button on "Wireless Infrastructure

 

Device Manager"

 

For WinXP: select Start>Control Panel>Add/Remove Programs

 

2 Click "Change/Remove" button on "Wireless Infrastructure Device

 

Manager"

 

3 When prompted to confirm, click OK.

 

 

Upgrading Ethernet

Firmware is the software that is installed on the Ethernet Adapter at the

Adapter Firmware

factory. Some problems can be solved by installing a new version of the

 

firmware.

 

For details on how to download a firmware update from the Enterasys

 

Networks customer support Web site and install it on your Ethernet

 

Adapter, see “Upgrading the System” on page 46.

Image 60
Contents RoamAbout Page Contents Obtaining Support for Your Enterasys Networks Product END User License Agreement Regulatory Information Page About this Guide Conventions List conventions that are used throughout this guideConventions Accessing Online RelatedDocumentation Product Registration Support About this Guide Introduction 802.11a 802.11gConfiguration NetworkPlanning Configurations Wireless Infrastructure NetworkExample Operating systems, and network printers, as shown in FigureUnpacking Ethernet AdapterEthernet Adapter Deciding Where to Place the Ethernet Adapter To wall-mount the Ethernet Adapter Place the Ethernet Adapter onto the wall, as shown in FigureConnecting Connect the powerInstalling the Ethernet Adapter Connecting to a Hub Indicators Checking the LEDAs follows LED Descriptions Need to Configure Attaching AnExternal Antenna Determining if youNetworks without a Dhcp Server Ethernet Adapter Default Settings Shows the Ethernet Adapter configuration factory defaultsUsing the Enterasys Networks Installation CD Installing the Ethernet Adapter Configuring the Ethernet Configuring the Ethernet Adapter Click Configure Button Description Using Configure the Ethernet Adapter through your Web browserManagement SystemClearing Applying System Configuration Settings System Properties Setting Description Wireless Network Select Specify the Wireless LAN Service Area to allow External and one internal antenna- this setting Set the Data Preamble No Security Open System 40/64-bit Shared Key WEP104/128-bit Shared Key 128/152-bit Shared KeyTkip Radius Authentication Server Settings Enables or disables Snmp Using the Configuration Management System Configuring Operation Mode About UartConfiguring Uart Settings Configuring Network Serial Port Settings0x34 0x31 0x33 0x39 Applying Settings Factory DefaultsTo restore the settings through software Click RestoreUsing FTP default Using Tftp Using HttpUnder Tools, click Backup Wireless Ethernet Adapter For details Click Refresh to update the information SummaryProblems DiagnosingFollowing table Troubleshooting Disconnecting the To disconnect the Ethernet Adapter SymptomSolutionsUninstalling SoftwareUpgrading Ethernet Adapter FirmwareEnterasys Networks using one of the following methods Getting HelpPage END User License Agreement Page Regulatory Information MANUFACTURER’S Declaration of Conformity Canada Industry Canada IC Europe EU Declaration of Conformity Bipt 108, 112, 116