Enterasys Networks RBTSA-AB, RBTSA-AA manual About this Guide

Page 7

ABOUT THIS GUIDE

This guide provides all the information you need to install and use the Enterasys Networks 11a/b/g Wireless Ethernet Adapter in its default state.

The guide is intended for use by IT managers and experienced network installation and administration professionals who have a basic knowledge of current networking concepts.

If the information in the release notes that are shipped with your product differ from the information in this guide, follow the instructions in the release notes.

Most user guides and release notes are available in Adobe Acrobat Reader Portable Document Format (PDF) or HTML on the Enterasys Networks World Wide Web site:

http://www.enterasys.com/products/wireless/

Image 7

Contents RoamAbout Page Contents Obtaining Support for Your Enterasys Networks Product END User License Agreement Regulatory Information Page About this Guide List conventions that are used throughout this guide ConventionsConventions Related Accessing OnlineDocumentation Product Registration Support About this Guide Introduction 802.11g 802.11aNetwork ConfigurationPlanning Operating systems, and network printers, as shown in Figure ConfigurationsWireless Infrastructure Network ExampleEthernet Adapter UnpackingEthernet Adapter Deciding Where to Place the Ethernet Adapter Place the Ethernet Adapter onto the wall, as shown in Figure To wall-mount the Ethernet AdapterConnect the power ConnectingInstalling the Ethernet Adapter Connecting to a Hub Checking the LED IndicatorsAs follows LED Descriptions Determining if you Need to ConfigureAttaching An External AntennaNetworks without a Dhcp Server Shows the Ethernet Adapter configuration factory defaults Ethernet Adapter Default SettingsUsing the Enterasys Networks Installation CD Installing the Ethernet Adapter Configuring the Ethernet Configuring the Ethernet Adapter Click Configure Button Description System UsingConfigure the Ethernet Adapter through your Web browser ManagementClearing Applying System Configuration Settings System Properties Setting Description Wireless Network Select Specify the Wireless LAN Service Area to allow External and one internal antenna- this setting Set the Data Preamble 128/152-bit Shared Key No Security Open System40/64-bit Shared Key WEP 104/128-bit Shared KeyTkip Radius Authentication Server Settings Enables or disables Snmp Using the Configuration Management System About Uart Configuring Operation ModeConfiguring Network Serial Port Settings Configuring Uart Settings0x34 0x31 0x33 0x39 Factory Defaults Applying SettingsClick Restore To restore the settings through softwareUsing FTP default Using Http Using TftpUnder Tools, click Backup Wireless Ethernet Adapter For details Summary Click Refresh to update the informationDiagnosing ProblemsFollowing table Troubleshooting SymptomSolutions Disconnecting the To disconnect the Ethernet AdapterAdapter Firmware UninstallingSoftware Upgrading EthernetGetting Help Enterasys Networks using one of the following methodsPage END User License Agreement Page Regulatory Information MANUFACTURER’S Declaration of Conformity Canada Industry Canada IC Europe EU Declaration of Conformity Bipt 108, 112, 116