Enterasys Networks RBTSA-AB, RBTSA-AA manual Using Tftp, Using Http

Page 53

Using the Configuration Management System 47

Using TFTP

The general instructions for installing the upgrade using TFTP are:

1Launch the Configuration Management System.

2Under Tools, click Upgrade System.

3Select TFTP.

4Enter the file name for the firmware.

5Enter the IP address of the TFTP server where the upgrade files are located.

6Click Upgrade.

Using HTTP

The general instructions for installing the upgrade using HTTP are:

1Launch the Configuration Management System.

2Under Tools, click Upgrade System.

3Select HTTP.

4Click Browse to locate the downloaded firmware file.

5Click Upgrade to start the upgrade process.

The upgrade takes place through the HTTP protocol from the local computer.

Changing the Enterasys Networks recommends that you set a password to protect Administration Login against unauthorized access. After you set the password, you must enter Name and Password it each time you launch the configuration for the device.

Under Tools, click Change Administration Password. The Change Administration Password page appears, where you can change the login name and administration password for the device. Enter the current password and new password in the spaces provided and click Save.

Image 53

Contents RoamAbout Page Contents Obtaining Support for Your Enterasys Networks Product END User License Agreement Regulatory Information Page About this Guide List conventions that are used throughout this guide ConventionsConventions Documentation Accessing OnlineRelated Product Registration Support About this Guide Introduction 802.11g 802.11aPlanning ConfigurationNetwork Wireless Infrastructure Network ConfigurationsExample Operating systems, and network printers, as shown in FigureEthernet Adapter UnpackingEthernet Adapter Deciding Where to Place the Ethernet Adapter Place the Ethernet Adapter onto the wall, as shown in Figure To wall-mount the Ethernet AdapterConnect the power ConnectingInstalling the Ethernet Adapter Connecting to a Hub As follows IndicatorsChecking the LED LED Descriptions Attaching An Need to ConfigureExternal Antenna Determining if youNetworks without a Dhcp Server Shows the Ethernet Adapter configuration factory defaults Ethernet Adapter Default SettingsUsing the Enterasys Networks Installation CD Installing the Ethernet Adapter Configuring the Ethernet Configuring the Ethernet Adapter Click Configure Button Description Configure the Ethernet Adapter through your Web browser UsingManagement SystemClearing Applying System Configuration Settings System Properties Setting Description Wireless Network Select Specify the Wireless LAN Service Area to allow External and one internal antenna- this setting Set the Data Preamble 40/64-bit Shared Key WEP No Security Open System104/128-bit Shared Key 128/152-bit Shared KeyTkip Radius Authentication Server Settings Enables or disables Snmp Using the Configuration Management System About Uart Configuring Operation ModeConfiguring Network Serial Port Settings Configuring Uart Settings0x34 0x31 0x33 0x39 Factory Defaults Applying SettingsUsing FTP default To restore the settings through softwareClick Restore Using Http Using TftpUnder Tools, click Backup Wireless Ethernet Adapter For details Summary Click Refresh to update the informationFollowing table ProblemsDiagnosing Troubleshooting SymptomSolutions Disconnecting the To disconnect the Ethernet AdapterSoftware UninstallingUpgrading Ethernet Adapter FirmwareGetting Help Enterasys Networks using one of the following methodsPage END User License Agreement Page Regulatory Information MANUFACTURER’S Declaration of Conformity Canada Industry Canada IC Europe EU Declaration of Conformity Bipt 108, 112, 116