Enterasys Networks RBTSA-AA, RBTSA-AB manual Ethernet Adapter Default Settings

Page 28

22CHAPTER 2: INSTALLING THE ETHERNET ADAPTER

Ethernet Adapter Default Settings

Table 4 shows the Ethernet Adapter configuration factory defaults.

Table 4 Factory Default Settings

Property

Default Setting

 

 

Device Name

RoamAbout Ethernet Adapter - RBTSA

Device Location

None (blank)

Country

For U.S. version, United States and Canada

 

For non-U.S. version, set by the user

Client Mode

Support multiple wired Ethernet clients

IP Network Setting

Obtain IP address automatically

IP Address

Obtained automatically (with a DHCP server)

 

169.254.2.2 (without a DHCP server)

Subnet Mask

Obtained automatically (with a DHCP server)

 

255.255.0.0 (without a DHCP server)

Gateway IP Address

Obtained automatically (with a DHCP server)

 

0.0.0.0 (without a DHCP server)

Network Mode

Wireless Client (Infrastructure)

Radio Mode

Auto Select

Wireless LAN Service Area

Attach to any WLAN Service Area (ESSID) automatically

Channel Selection

Automatic Best Channel (uses access point setting)

Transmit Power

100%

Antenna Selection

Internal

Data Preamble

Long (if Network Mode is set to Ad-Hoc)

 

Same as access point setting (if Network Mode is set

 

to Wireless Client [Infrastructure])

Security Setting

Open System (no security)

802.1x Authentication State

Disabled

SNMP

Enabled

Access Control List

Disabled

Administration Login Name

admin

Administration Password

None (blank)

TFTP Server IP Address

None

FTP Server IP Address

None

 

 

Image 28
Contents RoamAbout Page Contents Obtaining Support for Your Enterasys Networks Product END User License Agreement Regulatory Information Page About this Guide Conventions List conventions that are used throughout this guideConventions Related Accessing OnlineDocumentation Product Registration Support About this Guide Introduction 802.11a 802.11gNetwork ConfigurationPlanning Configurations Wireless Infrastructure NetworkExample Operating systems, and network printers, as shown in FigureUnpacking Ethernet AdapterEthernet Adapter Deciding Where to Place the Ethernet Adapter To wall-mount the Ethernet Adapter Place the Ethernet Adapter onto the wall, as shown in FigureConnecting Connect the powerInstalling the Ethernet Adapter Connecting to a Hub Checking the LED IndicatorsAs follows LED Descriptions Need to Configure Attaching AnExternal Antenna Determining if youNetworks without a Dhcp Server Ethernet Adapter Default Settings Shows the Ethernet Adapter configuration factory defaultsUsing the Enterasys Networks Installation CD Installing the Ethernet Adapter Configuring the Ethernet Configuring the Ethernet Adapter Click Configure Button Description Using Configure the Ethernet Adapter through your Web browserManagement SystemClearing Applying System Configuration Settings System Properties Setting Description Wireless Network Select Specify the Wireless LAN Service Area to allow External and one internal antenna- this setting Set the Data Preamble No Security Open System 40/64-bit Shared Key WEP104/128-bit Shared Key 128/152-bit Shared KeyTkip Radius Authentication Server Settings Enables or disables Snmp Using the Configuration Management System Configuring Operation Mode About UartConfiguring Uart Settings Configuring Network Serial Port Settings0x34 0x31 0x33 0x39 Applying Settings Factory DefaultsClick Restore To restore the settings through softwareUsing FTP default Using Tftp Using HttpUnder Tools, click Backup Wireless Ethernet Adapter For details Click Refresh to update the information SummaryDiagnosing ProblemsFollowing table Troubleshooting Disconnecting the To disconnect the Ethernet Adapter SymptomSolutionsUninstalling SoftwareUpgrading Ethernet Adapter FirmwareEnterasys Networks using one of the following methods Getting HelpPage END User License Agreement Page Regulatory Information MANUFACTURER’S Declaration of Conformity Canada Industry Canada IC Europe EU Declaration of Conformity Bipt 108, 112, 116