Enterasys Networks RBTSA-AB, RBTSA-AA manual LED Descriptions

Page 25

Checking the LED Indicators

19

Table 3	LED Descriptions

LED	Color	Indicates

Power	Green	The Ethernet Adapter is powered up and
		operating normally.
	Off	The Ethernet Adapter is not receiving power or
		there is a fault with the power supply.

11a	Green (solid)	The Ethernet Adapter has an 802.11a 5 GHz
		radio band connection.
	Green (blinking)	The Ethernet Adapter has WLAN frame
		transmission over the 802.11a 5 GHz radio band.
	Off	No link is present.

11b/g	Green (solid)	The Ethernet Adapter has an 802.11g 2.4 GHz
		radio band connection.
	Green (blinking)	The Ethernet Adapter has WLAN frame
		transmission over the 802.11g 2.4 GHz radio band.
	Off	No link is present.

100	Green (solid)	The Ethernet Adapter has a 100 Mbps Fast
		Ethernet connection.
	Green (blinking)	The Ethernet Adapter has 100 Mbps Fast
		Ethernet activity.
	Off	No link is present.

10	Green (solid)	The Ethernet Adapter has a 10 Mbps Ethernet
		connection.
	Green (blinking)	The Ethernet Adapter has 10 Mbps Ethernet
		activity.
	Off	No link is present.

Image 25

Contents RoamAbout Page Contents Obtaining Support for Your Enterasys Networks Product END User License Agreement Regulatory Information Page About this Guide List conventions that are used throughout this guide ConventionsConventions Related Accessing OnlineDocumentation Product Registration Support About this Guide Introduction 802.11g 802.11aNetwork ConfigurationPlanning Wireless Infrastructure Network ConfigurationsExample Operating systems, and network printers, as shown in FigureEthernet Adapter UnpackingEthernet Adapter Deciding Where to Place the Ethernet Adapter Place the Ethernet Adapter onto the wall, as shown in Figure To wall-mount the Ethernet AdapterConnect the power ConnectingInstalling the Ethernet Adapter Connecting to a Hub Checking the LED IndicatorsAs follows LED Descriptions Attaching An Need to ConfigureExternal Antenna Determining if youNetworks without a Dhcp Server Shows the Ethernet Adapter configuration factory defaults Ethernet Adapter Default SettingsUsing the Enterasys Networks Installation CD Installing the Ethernet Adapter Configuring the Ethernet Configuring the Ethernet Adapter Click Configure Button Description Configure the Ethernet Adapter through your Web browser UsingManagement SystemClearing Applying System Configuration Settings System Properties Setting Description Wireless Network Select Specify the Wireless LAN Service Area to allow External and one internal antenna- this setting Set the Data Preamble 40/64-bit Shared Key WEP No Security Open System104/128-bit Shared Key 128/152-bit Shared KeyTkip Radius Authentication Server Settings Enables or disables Snmp Using the Configuration Management System About Uart Configuring Operation ModeConfiguring Network Serial Port Settings Configuring Uart Settings0x34 0x31 0x33 0x39 Factory Defaults Applying SettingsClick Restore To restore the settings through softwareUsing FTP default Using Http Using TftpUnder Tools, click Backup Wireless Ethernet Adapter For details Summary Click Refresh to update the informationDiagnosing ProblemsFollowing table Troubleshooting SymptomSolutions Disconnecting the To disconnect the Ethernet AdapterSoftware UninstallingUpgrading Ethernet Adapter FirmwareGetting Help Enterasys Networks using one of the following methodsPage END User License Agreement Page Regulatory Information MANUFACTURER’S Declaration of Conformity Canada Industry Canada IC Europe EU Declaration of Conformity Bipt 108, 112, 116