Enterasys Networks RBTSA-AB, RBTSA-AA manual Click Configure

Page 33

Using the Enterasys Networks Wireless Infrastructure Device Manager

27

The tree lists all WLAN service areas on the network and expands to show the Enterasys Networks wireless LAN devices that are associated to each service area. Devices in a different subnet than your computer are identified with exclamation points (!). You can refresh this display by clicking Refresh. You should refresh the display, for example, after you change a device IP address.

Figure 12 Wireless Infrastructure Device Manager Wireless Network Tree

2In the Wireless Network Tree, select the device you want to configure.

If more than one wireless LAN device appears in the tree and you are not sure that you have selected the right one, click Properties and check the MAC address to verify that it is the one you want.

3Click Configure.

■If the selected device is on the same subnet as your computer, the Configuration Management System main page appears in your Web browser. See “Using the Configuration Management System” on page 29, for details.

■If the selected device is on a different subnet, the device manager helps you to assign an IP address on the same subnet as your computer, as shown in Figure 13. You may accept the address offered or enter an address and click Next.

Image 33

Contents RoamAbout Page Contents Obtaining Support for Your Enterasys Networks Product END User License Agreement Regulatory Information Page About this Guide List conventions that are used throughout this guide ConventionsConventions Accessing Online RelatedDocumentation Product Registration Support About this Guide Introduction 802.11g 802.11aConfiguration NetworkPlanning Wireless Infrastructure Network ConfigurationsExample Operating systems, and network printers, as shown in FigureEthernet Adapter UnpackingEthernet Adapter Deciding Where to Place the Ethernet Adapter Place the Ethernet Adapter onto the wall, as shown in Figure To wall-mount the Ethernet AdapterConnect the power ConnectingInstalling the Ethernet Adapter Connecting to a Hub Indicators Checking the LEDAs follows LED Descriptions Attaching An Need to ConfigureExternal Antenna Determining if youNetworks without a Dhcp Server Shows the Ethernet Adapter configuration factory defaults Ethernet Adapter Default SettingsUsing the Enterasys Networks Installation CD Installing the Ethernet Adapter Configuring the Ethernet Configuring the Ethernet Adapter Click Configure Button Description Configure the Ethernet Adapter through your Web browser UsingManagement SystemClearing Applying System Configuration Settings System Properties Setting Description Wireless Network Select Specify the Wireless LAN Service Area to allow External and one internal antenna- this setting Set the Data Preamble 40/64-bit Shared Key WEP No Security Open System104/128-bit Shared Key 128/152-bit Shared KeyTkip Radius Authentication Server Settings Enables or disables Snmp Using the Configuration Management System About Uart Configuring Operation ModeConfiguring Network Serial Port Settings Configuring Uart Settings0x34 0x31 0x33 0x39 Factory Defaults Applying SettingsTo restore the settings through software Click RestoreUsing FTP default Using Http Using TftpUnder Tools, click Backup Wireless Ethernet Adapter For details Summary Click Refresh to update the informationProblems DiagnosingFollowing table Troubleshooting SymptomSolutions Disconnecting the To disconnect the Ethernet AdapterSoftware UninstallingUpgrading Ethernet Adapter FirmwareGetting Help Enterasys Networks using one of the following methodsPage END User License Agreement Page Regulatory Information MANUFACTURER’S Declaration of Conformity Canada Industry Canada IC Europe EU Declaration of Conformity Bipt 108, 112, 116