Enterasys Networks RBTSA-AA, RBTSA-AB manual Button Description

Page 34

28CHAPTER 3: CONFIGURING THE ETHERNET ADAPTER

Figure 13 Wireless Infrastructure Device Manager Pre-IP Configuration

4The next window prompts for an administrative password to allow the new IP address to be set. If this is the first time the device is being configured, leave the password field blank and click Next.

The configuration main page appears in your Web browser. See “Using the Configuration Management System” on page 29 for details.

Table 7 describes the functions of the buttons in the Enterasys Networks Wireless Infrastructure Device Manager window.

Table 7 Infrastructure Device Manager Options

Button

Description

 

 

Properties

Displays the following properties of the selected device:

 

Device Name, Device Type, Wireless LAN Service Area (ESSID),

 

IP Address, Subnet Mask, and MAC Address.

Configure

Launches the Configuration Management System for the

 

selected device. If the selected device is on a different subnet,

 

you are prompted to assign an address on the same subnet as

 

your computer.

Refresh

Scans the network and displays the connected Enterasys

 

Networks 11a/b/g Wireless LAN devices.

Choose NIC

If your computer has more than one network interface card

 

installed, allows you to choose which card to use.

Close

Closes the device manager window and ends the session.

Help

Launches the device manager help page in your browser.

 

 

Image 34
Contents RoamAbout Page Contents Obtaining Support for Your Enterasys Networks Product END User License Agreement Regulatory Information Page About this Guide Conventions List conventions that are used throughout this guideConventions Related Accessing OnlineDocumentation Product Registration Support About this Guide Introduction 802.11a 802.11gNetwork ConfigurationPlanning Example ConfigurationsWireless Infrastructure Network Operating systems, and network printers, as shown in FigureUnpacking Ethernet AdapterEthernet Adapter Deciding Where to Place the Ethernet Adapter To wall-mount the Ethernet Adapter Place the Ethernet Adapter onto the wall, as shown in FigureConnecting Connect the powerInstalling the Ethernet Adapter Connecting to a Hub Checking the LED IndicatorsAs follows LED Descriptions External Antenna Need to ConfigureAttaching An Determining if youNetworks without a Dhcp Server Ethernet Adapter Default Settings Shows the Ethernet Adapter configuration factory defaultsUsing the Enterasys Networks Installation CD Installing the Ethernet Adapter Configuring the Ethernet Configuring the Ethernet Adapter Click Configure Button Description Management UsingConfigure the Ethernet Adapter through your Web browser SystemClearing Applying System Configuration Settings System Properties Setting Description Wireless Network Select Specify the Wireless LAN Service Area to allow External and one internal antenna- this setting Set the Data Preamble 104/128-bit Shared Key No Security Open System40/64-bit Shared Key WEP 128/152-bit Shared KeyTkip Radius Authentication Server Settings Enables or disables Snmp Using the Configuration Management System Configuring Operation Mode About UartConfiguring Uart Settings Configuring Network Serial Port Settings0x34 0x31 0x33 0x39 Applying Settings Factory DefaultsClick Restore To restore the settings through softwareUsing FTP default Using Tftp Using HttpUnder Tools, click Backup Wireless Ethernet Adapter For details Click Refresh to update the information SummaryDiagnosing ProblemsFollowing table Troubleshooting Disconnecting the To disconnect the Ethernet Adapter SymptomSolutionsUpgrading Ethernet UninstallingSoftware Adapter FirmwareEnterasys Networks using one of the following methods Getting HelpPage END User License Agreement Page Regulatory Information MANUFACTURER’S Declaration of Conformity Canada Industry Canada IC Europe EU Declaration of Conformity Bipt 108, 112, 116