Enterasys Networks RBTSA-AB, RBTSA-AA manual Applying Settings, Factory Defaults

Page 51

Using the Configuration Management System 45

Applying Settings

After you set the UART settings, network serial port settings, and operation mode, select Apply to make the settings take effect.

Resetting the If the Ethernet Adapter stops responding correctly, you can perform a Ethernet Adapter reset, which disrupts the network association temporarily, but does not

affect Ethernet Adapter configuration settings that have already been applied with Apply.

To reset the Ethernet Adapter, under Tools, click Reset Wireless Ethernet

Adapter. In the next page, click Reset.

The Ethernet Adapter can also be reset using the Wireless Infrastructure Device Manager (Widman). Right-click the Ethernet Adapter in Widman, and then select Reset.

Restoring the You can restore Ethernet Adapter settings to the defaults that were set at Ethernet Adapter to the factory either manually or through software.

Factory Defaults

To restore the settings manually, insert a pointed object (such as the end of a straightened paper clip) into the reset hole on the back of the Ethernet Adapter, and hold for five seconds.

Figure 14 Manually Resetting the Ethernet Adapter

Reset Hole

RESET

Image 51
Contents RoamAbout Page Contents Obtaining Support for Your Enterasys Networks Product END User License Agreement Regulatory Information Page About this Guide List conventions that are used throughout this guide ConventionsConventions Accessing Online RelatedDocumentation Product Registration Support About this Guide Introduction 802.11g 802.11aConfiguration NetworkPlanning Operating systems, and network printers, as shown in Figure ConfigurationsWireless Infrastructure Network ExampleEthernet Adapter UnpackingEthernet Adapter Deciding Where to Place the Ethernet Adapter Place the Ethernet Adapter onto the wall, as shown in Figure To wall-mount the Ethernet AdapterConnect the power ConnectingInstalling the Ethernet Adapter Connecting to a Hub Indicators Checking the LEDAs follows LED Descriptions Determining if you Need to ConfigureAttaching An External AntennaNetworks without a Dhcp Server Shows the Ethernet Adapter configuration factory defaults Ethernet Adapter Default SettingsUsing the Enterasys Networks Installation CD Installing the Ethernet Adapter Configuring the Ethernet Configuring the Ethernet Adapter Click Configure Button Description System UsingConfigure the Ethernet Adapter through your Web browser ManagementClearing Applying System Configuration Settings System Properties Setting Description Wireless Network Select Specify the Wireless LAN Service Area to allow External and one internal antenna- this setting Set the Data Preamble 128/152-bit Shared Key No Security Open System40/64-bit Shared Key WEP 104/128-bit Shared KeyTkip Radius Authentication Server Settings Enables or disables Snmp Using the Configuration Management System About Uart Configuring Operation ModeConfiguring Network Serial Port Settings Configuring Uart Settings0x34 0x31 0x33 0x39 Factory Defaults Applying SettingsTo restore the settings through software Click RestoreUsing FTP default Using Http Using TftpUnder Tools, click Backup Wireless Ethernet Adapter For details Summary Click Refresh to update the informationProblems DiagnosingFollowing table Troubleshooting SymptomSolutions Disconnecting the To disconnect the Ethernet AdapterAdapter Firmware UninstallingSoftware Upgrading EthernetGetting Help Enterasys Networks using one of the following methodsPage END User License Agreement Page Regulatory Information MANUFACTURER’S Declaration of Conformity Canada Industry Canada IC Europe EU Declaration of Conformity Bipt 108, 112, 116