Edimax Technology Wireless Broadband Router manual 2d Windows NT

Page 11

2d) Windows NT

1.Click the Start button and select Settings, then click Control Panel. The Control Panel window will appear.

2.Double-click Network icon. The Network window will appear. Select the Protocol tab from the Network window.

3.Check if the TCP/IP Protocol is on your list of Network Protocols. If TCP/IP is not installed, click the Add button to install it now. If TCP/IP is installed, go to step 5.

4.In the Select Network Protocol window, select the TCP/IP Protocol and click the Ok button to start installing the TCP/IP protocol. You may need your Windows CD to complete the installation.

5.After you install TCP/IP, go back to the Network window. Select TCP/IP from the list of Network Protocols and then click the Properties button.

6.Check each of the tabs and verify the following settings:

•IP Address: Select Obtain an IP address from a DHCP server.

•DNS: Let all fields are blank.

•WINS: Let all fields are blank.

•Routing: Let all fields are blank.

10

Image 11

Contents User’s Manual Page NAT Minimum Requirements FeaturesPackage Content Wide Area Network WAN ResetGet to know the Broadband Router Back Panel Local Area Network LANLight Status Description Front PanelGetting started Setup DiagramConfigure your PC to obtain an IP address automatically DNS Configuration Select Disable DNS 2b Windows XP 2c Windows IP Address Select Obtain an IP address from a Dhcp server 2d Windows NTPage General Setup Chapter Quick Setup Wizard ChapterTime Zone Quick SetupStatus Info. Chapter System Tools ChapterBroadband Type L2TP PptpCable Modem DNS Fixed-IP xDSLPPPoE MTU Pptp BEZEQ-ISRAEL L2TP Type in this MAC address in this section or use Telstra Big Pond Turn OFF the Router When YOU Finished Using the InternetGeneral Settings LAN WANSystem NATTime Zone Password Settings Remote Management WAN Page PPPoE PPP over Ethernet Wireless ISPDynamic IP Static IP Address8 DNS Ddns LAN IP LANFrom network loop happened Setting WirelessBasic Settings Wlan MAC EssidAdvanced Settings Page Security IappWEP only 3.2 802.1x only WPA Pre-shared key 3.3 802.1x WEP Static keyWPA2AES WpatkipWPA Radius Access Control QoS Page Edit QoS Rule Will apply to. You can assign a single port number NAT Port Forwarding Page Virtual Server Page Special Applications Example Virtual ServerPage Example Example Special ApplicationsUPnP Settings ALG Settings Static Routing Firewall Access Control Rule for users by IP addresses Add PC Example Access Control Client PC ServiceURL Blocking Intrusion Detection Feature DoS Denial of Service4 DMZ Status Status and Information Primary DNS and Secondary DNS being used Internet ConnectionDevice Status System Log Security Log Active Dhcp Client Statistics Tool Restore to Factory Defaults tool to force Configuration ToolsFirmware Upgrade Perform a reset. Your settings will not be Appendix a How to Manually find your PC’s IP and MAC address Glossary Page UDP TCP FTP Smtp POP3TCP Snmp UCP