Edimax Technology Wireless Broadband Router manual System Log

Page 77

3.4 System Log

View the operation log of the system.

Parameters

Description

System Log

This page shows the current system log of the

 

Broadband router. It displays any event occurred

 

after system start up.

 

At the bottom of the page, the system log can be

 

saved <Save> to a local file for further processing or

 

the system log can be cleared <Clear> or it can be

 

refreshed <Refresh> to get the most updated

 

situation. When the system is powered down, the

 

system log will disappear if not saved to a local file.

 

 

76

Image 77
Contents User’s Manual Page NAT Minimum Requirements FeaturesPackage Content Get to know the Broadband Router Back Panel ResetLocal Area Network LAN Wide Area Network WANLight Status Description Front PanelGetting started Setup DiagramConfigure your PC to obtain an IP address automatically DNS Configuration Select Disable DNS 2b Windows XP 2c Windows IP Address Select Obtain an IP address from a Dhcp server 2d Windows NTPage General Setup Chapter Quick Setup Wizard ChapterStatus Info. Chapter Quick SetupSystem Tools Chapter Time ZoneBroadband Type L2TP PptpCable Modem DNS Fixed-IP xDSLPPPoE MTU Pptp BEZEQ-ISRAEL L2TP Type in this MAC address in this section or use Telstra Big Pond Turn OFF the Router When YOU Finished Using the InternetGeneral Settings LAN WANSystem NATTime Zone Password Settings Remote Management WAN Page Dynamic IP Wireless ISPStatic IP Address PPPoE PPP over Ethernet8 DNS Ddns LAN IP LANFrom network loop happened Setting WirelessBasic Settings Wlan MAC EssidAdvanced Settings Page Security IappWEP only 3.2 802.1x only WPA Pre-shared key 3.3 802.1x WEP Static keyWPA2AES WpatkipWPA Radius Access Control QoS Page Edit QoS Rule Will apply to. You can assign a single port number NAT Port Forwarding Page Virtual Server Page Special Applications Example Virtual ServerPage Example Example Special ApplicationsUPnP Settings ALG Settings Static Routing Firewall Access Control Rule for users by IP addresses Add PC Example Access Control Client PC ServiceURL Blocking Intrusion Detection Feature DoS Denial of Service4 DMZ Status Status and Information Primary DNS and Secondary DNS being used Internet ConnectionDevice Status System Log Security Log Active Dhcp Client Statistics Tool Restore to Factory Defaults tool to force Configuration ToolsFirmware Upgrade Perform a reset. Your settings will not be Appendix a How to Manually find your PC’s IP and MAC address Glossary Page TCP TCP FTP Smtp POP3Snmp UCP UDP