Edimax Technology Wireless Broadband Router manual Advanced Settings

Clone MAC	Click the “Clone MAC” button will copy the MAC
	address of your PC, that you are using to
	configure the AP, to the WLAN MAC.
MAC address	If you want to bridge more than one networks
	together with wireless LAN, you have to set this
	access point to “AP Bridge-Point to Point mode”,
	“AP Bridge-Point to Multi-Point mode” or “AP
	Bridge-WDS mode”. You have to enter the
	MAC addresses of other access points that join
	the bridging work.
Set Security	Click the “Set Security” button, then a “WDS
	Security Settings” will pop up. You can set the
	security parameters used to bridge access
	points together here when your AP is in AP
	Bridge modes. You can refer to section 4.3
	“Security Settings” for how to set the
	parameters.

Click <Apply> at the bottom of the screen to save the above configurations. You can now configure other advance sections or start using the router (with the advance settings in place)

2.4.2 Advanced Settings

You can set advanced wireless LAN parameters of this router. The parameters include Authentication Type, Fragment Threshold, RTS Threshold, Beacon Interval, Preamble Type …… You should not change

these parameters unless you know what effect the changes will have on this router.

40