Edimax Technology Wireless Broadband Router manual Client PC Service, Example Access Control

Page 69

 

Note: You need to give your LAN PC clients a

 

fixed/static IP address for the Access Control

 

rule to work properly.

Client PC Service

You can block the clients from accessing some

 

Internet services by checking the services you

 

want to block.

Protocol

This allows you to select UDP, TCP or both

 

protocol type you want to block.

Port Range

It can be assign up to five port ranges. The

 

router will block clients from accessing Internet

 

services that use these ports.

Apply Changes

Click “Apply Changes” to save the setting.

Reset

Click “Reset” to clear all fields.

Click <Apply Changes> at the bottom of the screen to save the above configurations. You can now configure other advance sections or start using the router (with the advance settings in place)

Example: Access Control

In the example below, LAN client A can only access websites that use Port

80.However, LAN client B is able to access websites and any other service that uses ports between 80 and 999.

68

Image 69
Contents User’s Manual Page NAT Features Package ContentMinimum Requirements Get to know the Broadband Router Back Panel ResetLocal Area Network LAN Wide Area Network WANLight Status Description Front PanelSetup Diagram Configure your PC to obtain an IP address automaticallyGetting started DNS Configuration Select Disable DNS 2b Windows XP 2c Windows IP Address Select Obtain an IP address from a Dhcp server 2d Windows NTPage General Setup Chapter Quick Setup Wizard ChapterStatus Info. Chapter Quick SetupSystem Tools Chapter Time ZoneBroadband Type L2TP PptpCable Modem DNS Fixed-IP xDSLPPPoE MTU Pptp BEZEQ-ISRAEL L2TP Type in this MAC address in this section or use Telstra Big Pond Turn OFF the Router When YOU Finished Using the InternetGeneral Settings LAN WANSystem NATTime Zone Password Settings Remote Management WAN Page Dynamic IP Wireless ISPStatic IP Address PPPoE PPP over Ethernet8 DNS Ddns LAN IP LANFrom network loop happened Wireless Basic SettingsSetting Wlan MAC EssidAdvanced Settings Page Security IappWEP only 3.2 802.1x only WPA Pre-shared key 3.3 802.1x WEP Static keyWPA2AES WpatkipWPA Radius Access Control QoS Page Edit QoS Rule Will apply to. You can assign a single port number NAT Port Forwarding Page Virtual Server Page Special Applications Example Virtual ServerPage Example Example Special ApplicationsUPnP Settings ALG Settings Static Routing Firewall Access Control Rule for users by IP addresses Add PC Example Access Control Client PC ServiceURL Blocking Intrusion Detection Feature DoS Denial of Service4 DMZ Status Status and Information Primary DNS and Secondary DNS being used Internet ConnectionDevice Status System Log Security Log Active Dhcp Client Statistics Tool Restore to Factory Defaults tool to force Configuration ToolsFirmware Upgrade Perform a reset. Your settings will not be Appendix a How to Manually find your PC’s IP and MAC address Glossary Page TCP TCP FTP Smtp POP3Snmp UCP UDP