DS72 Host Module
Figure 2
DS72 Data Switch Series - Telnet | Host Module | |||
Revision F.3.21.4 | Kernel | K.1.01H |
| |
Core | C.1.00N | Hardware | H.2.01 |
|
Module 2 |
|
|
|
|
Status |
| 1 | Current status of DS72 module | |
Serial Port Configuration | 2 | Change port config, 9600, 8, 1, none | ||
Port Device Name | 3 | Change the name of the module port | ||
Attention Character | 4 | (;;;;;) get Main Menu | ||
Disconnect Timeguard | 5 | Delay to see if more data after ‘;’ | ||
char |
|
| 6 | User override another for priority |
Connection Override | ||||
Connect Port ID Echo | 7 | Enable echo module & port#, device | ||
name |
|
| 8 | Manage User, Port, Header |
Login Setup | ||||
SNMP Configuration | 9 | Trap Address, Read/Write, | ||
Enable/Disable |
| 10 | Ethernet configuration menu | |
Network Port Configuration | ||||
Unit ID |
| 11 | Name of the module | |
Upgrade Firmware | 12 | |||
Active Restore | 13 | Allow units to internally reset for | ||
RPC Management |
| 14 | freezes, login idle timeouts, | |
Set thresholds temp/v/c | ||||
Exit |
| X,CR |
| |
Enter Request :1 |
|
|
| |
Select option ‘8’ to add users with passwords and Enable/Disable access to the Network and Serial ports. Select option ‘10’ to configure the Ethernet port
Login Setup
Figure 3
Header | 1 | Enable/Disable Header for each menu |
Access Control | 2 | Enable/Disable Network/Serial port |
Manage Users | 3 | user name and password |
Add/Delete users and change passwords | ||
Exit | X,CR |
|
Header
This allows the admin to have enable or disable Header upon connection to the host module.
Access Control
This security feature allows the admin to enable or disable usernames and passwords for both serial and modem port access.
Manage Users
This option allows the administrator to change user passwords or add/delete new users. Up to 19 users plus an administrator allowed. Usernames are case sensitive and alphanumeric.
9