DS72 Host Module
Configuration Menu
The configuration menu allows the admin user to choose a module to access and edit its configuration. The following pages define each line of the configuration menu.
Configuration | 1 | Host Module |
DS72 | ||
DS74 Module# 3 | 2 | I/O Serial port |
| 3 | Assign users, outlet name, E/D |
|
| confirmation/status menu, unit id, |
Exit | X,CR | alarm set. |
|
Enter the number that corresponds with the Host Module followed by a <cr> and the Host Module responds without the option description:
Copyright(C) Bay Technical Associates | 1999 | |||
DS72 Data Switch Series - Telnet | Host Module | |||
Revision F.3.21.4 | Kernel | K.1.01H | ||
Core | C.1.00N | Hardware | H.2.01 | |
Module 2 |
|
|
|
|
Status |
| 1 | Current status of DS72 module | |
Serial Port Configuration | 2 | Change port config, 9600, 8, 1, none | ||
Port Device Name | 3 | Change the name of the module port | ||
Attention Character | 4 | (;;;;;) get Main Menu | ||
Disconnect Timeguard | 5 | Delay to see if more data after ‘;’ char | ||
Connection Override | 6 | User override another for priority | ||
Connect Port ID Echo | 7 | Enable echo module & port#, device name | ||
Login Setup | 8 | Manage User, Port, Header | ||
SNMP Configuration | 9 | Trap Address, Read/Write, Enable/Disable | ||
Network Port Configuration | 10 | Ethernet configuration menu | ||
Unit ID |
| 11 | Name of the module | |
Upgrade Firmware | 12 | |||
Active Restore | 13 | Allow units to internally reset for | ||
RPC Management |
| 14 | freezes, login idle timeouts, | |
Set thresholds temp/v/c | ||||
Exit |
| X,CR |
| |
Enter Request :1 |
|
|
| |
Configuration Status
Used to view the status of the installed modules, network setup, login setup, and associated information by issuing a series of carriage returns. The following are the factory default settings:
14