Bay Technical Associates manual DS72 Setup, Cabling

Page 35

DS72 Host Module

DS72 External Modem Configuration

The DS72 network controller module can be controlled remotely by an external modem. To achieve this level of access please follow the instructions listed below.

DS72 Setup

The DS72 needs the DCD configured properly to work with an external modem. To configure the DCD:

1.Power down the DS base unit.

2.Remove the DS72 network controller.

3.While holding the face plate in your right hand locate the EIA-232 port.

4.Locate where the EIA-232 port connects to the PC board of the DS72.

5.Locate the DCD In/Out jumpers on either side of the EIA-232 port.

6.Move the DCD In jumper from GND to DCD In. See Figure 1

7.Place the DS72 controller back into the base unit.

8.Power up the base unit.

External Modem Setup

The external modem has to have a certain configuration for it to function properly with the DS72. Verify the following Configuration:

1.Data Terminal Ready (DTR) Normal

2.Verbal Result Codes

3.Suppress Result Code

4.No Echo

5.Auto Answer 1st Ring

6.Carrier Detect (CD) Normal

7.Load NVRAM Defaults

8.Smart Mode

Cabling

Make sure that the proper cabling is being used to connect the external modem to the serial port on the DS72. In most cases the combination of the 25MRJ45MD-6 adapter and the RJ08X007 cable is needed. If you have any questions about cabling please contact the BayTech Support team at 800.523.2702 or at support@baytech.net.

35

Image 35
Contents DS Series Manual DS72 Host Module EIA-232 Serial Connection DS72 Host Module Connection Description Power InstallationQuick Start DS72 Module Ethernet Controller ConfigurationMain Menu Serial Port SetupManage Users Login SetupAccess Control HeaderNetwork Port Configuration RJ-45 Cables and Adapters Adapters SignalsCabling Adapters Main Screen Detailed Operation and ConfigurationConfiguration Status Configuration MenuDS72 Host Module Serial Port ConfigurationStop Bits Baud RateWord Size RTS/DTR Line Driver Inactivity State ParityXon/Xoff Connect Port ID Echo Serial Port Device NameDisconnect Timeguard Connection OverrideHeader Access ControlAdd User Change User’s PasswordManage Users Delete User Snmp ConfigurationRead/Write Community String Snmp EnableSnmp Trap Host X IP Address IP Address Carriage Return Translation Inactivity TimeoutSubnet Mask GatewayBreak Length DHCP/Telnet/BootPUnit ID Active Restore Upgrade FirmwareMultiple Strip Current Monitor Temperature Alarm ThresholdUnder Voltage Alarm Threshold RPC ManagementEnvironmental Sensors Over Voltage Alarm ThresholdLow Current Alarm Threshold Selection 1, the Host Module responds System StatusLogged Users Unit ResetTroubleshooting Network InterfaceNetwork session locks up Password not WorkNo Access to Configuration Menu No Menu Ethernet PortVerify DS chassis, Host module, and DS74 is functioning No Outlets displayed for UserNot able to Ping unit DS72 Host Module Cabling DS72 SetupExceptions BayTech Product WarrantyEmail support@baytech.net Technical SupportReturn Authorization Process
Related manuals
Manual 35 pages 54.1 Kb