BEFORE PLAYBACK-
HOLD switch + 0
Release the HOLD switch before pIayback: +@
When not using the unit, set the HOLD switch to the
HOLD position.Accidentally pressed button will not function. +0
If buttons are pressed when the HOLD switch is set to HOLD position, “HOLd”flashes in the display.
Turning on and off+@
Turning the power on
Press>ll PLAY/PAUSE. Power is turned on and playback starts.
Turning off the power
If no new operation is made after 30 seconds from the
end of last operation, the power is turned off automatically. (Auto power off function)
●You can turn off the power before it is automatically turned off by pressing the ❑ STOP/OFF/CHARGE,
Standby mode + @
When an operation finishes, the unit goes into standby mode until the auto power off function automatically turns off the power.
To enter standby mode, press ➤11PLAY/PAUSE to start playback, then press HSTOP/OFF/CHARGE.
Adjusting the sound + 0
Volume
Turn the VOL control to adjust the volume,
DSL
Set the DSL switch for more powerful sound and deeper bass.
1:Deep bass is emphasized,
2:Deep bass is more emphasized. OFF: Normal sound
Inserting a disc+@
1Slide OPEN to open the disc compartment.
2Place a disc in the center with the label side facing up.
3Close the compartment.
To remove the disc+ O
Pick up the disc holding its edge, while pressing the pivot gently.