5.4. Visual/Audible Call Alert Options
5.4.1.1.Receiving notification mode option (AT$$RCV_MODE))
This command is used for selecting preferred mode of incoming call alert.
Table
Command | TE2 | Æ |
| MT2 | $$RCVMODE? |
Response | TE2 | Å |
| MT2 | $$RCV_MODE: <value> |
| 0: LED with Ring (Default) | ||||
Value | 1: LED only |
|
| ||
| 2: Ring Only |
|
| ||
Table |
|
| |||
Command | TE2 | Æ |
| MT2 | $$RCV_MODE=<value> |
Response | TE2 | Å |
| MT2 | $$RCV_MODE: 1 0 (Success Failure) |
|
|
|
|
|
|
5.4.1.2.Ringer volume control (AT$$RINGLVL)
The command is used to test or set ringer volume level. MT2 applies new setting after TE2 reads or changes the volume setting.
This command causes the MT2 to ring once at current or set level.
Table
Command | TE2 | Æ |
| MT2 | $$RINGLVL? |
Response | TE2 | Å |
| MT2 | $$RINGLVL: <value> |
Value | ring level: (0~4) (0: mute) Default: 2 | ||||
Table |
|
| |||
Command | TE2 | Æ |
| MT2 | $$RINGLVL=<value> |
Response | TE2 | Å |
| MT2 | <result_code> (OK ERROR) |
|
|
|
|
|
|
5.4.1.3.Ringer melody selection (AT$$RINGIDX)
This command is used to test or set ringer melody. MT2 applies new setting when TE2 reads or changes the ringer melody setting.
This command causes the MT2 to ring once at current or set level.
Table
Command | TE2 | Æ | MT2 | $$RINGIDX? |
Response | TE2 | Å | MT2 | $$RINGIDX: <value> |
Value | Current melody Index (0~4) Default: 0 | |||
|
|
|
|
|
Table
Command TE2
Æ
MT2
$$RINGIDX=<value>
Extended AT Commands Manual | Page 24 of 70 |