Maxon Telecom MM-6280IND manual Basic S registers

Parameter	Description		Packet	STU-
			Data	III
&C1	Circuit 109 (CF) ON in accordance with the specified		R	N/A
	service. DCD line is High during a circuit switched call.
	Circuit 109 (CF) ON. DCD is always high. This line toggles
&C2	low for 1 second when the circuit switched call is		R	N/A
	disconnected.
	Circuit 109 (CF) ON. DCD is Low. High when modem has
&C3	successfully established a PPP Data (packet switched) call		R	N/A
	(only applies to IP STACK)
	Circuit 109 (CF) ON. DCD is Low. High when modem has
&C4	successfully established a PPP Data and opened a socket		R	N/A
	with remote server(packet switched) call (only applies to
	IP STACK)
&D0	Ignore circuit 108/2 (CD).		R	N/A
[&D1]	Enter online command state following ON-to-OFF transition
	of circuit 108/2. See service specific AT command processing		R	N/A
	for service state transitions.
&D2	Enter command state following On to Off transition of
	circuit 108/2. See service specific AT command		R	N/A
	processing for service state processing requirements.
T	Select tone dialling.	N/A		N/A
&F0	Set to factory-defined configuration. Effect is		O	N/A
	implementation dependent.

12.2.2. Basic S registers

The following table specifies the basic S registers to be supported for the data services. Exceptions to EIA/TIA-602 are indicated by square brackets. Default settings are shown in bold.

Table 12.79 Basic S-registers

Register		Value	Description			Packet		STU-
						Data		III
		[1 to 255]	Automatic	answering. [Enable	automatic
S0			answering after (Value: 1) x 6 seconds.]			N/A		N/A
	0
			0: Not Answer
S3	13		Carriage Return character.			O		N/A
S4	10		Line Feed character.			O		N/A
S5	8		Backspace character.			O		N/A
S6		2 to 10	Pause before blind dialling.			N/A		N/A
	2
Extended AT Commands Manual				Page 57 of 70			2009-06-25