Command | TE2 | Æ | MT2 | $$RINGIDX=<value> |
Response | TE2 | Å | MT2 | <result_code> (OK ERROR) |
|
|
|
|
|
5.5.Network Relational Settings
5.5.1.1.Roaming indicator information (AT$$ROAMIND)
This command is used for reading Roaming Indicator Information.
Table
Command | TE2 | Æ | MT2 | $$ROAMIND |
Response | TE2 | Å | MT2 | $$ROAMIND: <value> |
| 0: Not Roaming |
| ||
Value | 1: Roaming inside preferred roaming list | |||
| 2: Roaming outside preferred roaming list | |||
|
|
|
|
|
5.5.1.2.Antenna Signal Level report schedule (AT$$ANTSET)
The command is used for reading or setting the notification period of $$ANTLVL notification in seconds. If no changes are monitored $$ANTLVL does not report to $$ANTSET values.
Table
| Command |
|
| TE2 | Æ |
| MT2 | $$ANTSET? |
| Response |
| TE2 | Å |
| MT2 | $$ANTSET: <value> | |
| Value |
|
| 0: Read once |
|
| ||
|
|
| 1~43200: Notification every <x> seconds | |||||
|
|
|
| |||||
| Table |
|
| |||||
| Command |
| TE2 | Æ |
| MT2 | $$ANTSET=<value> | |
| Response |
|
| TE2 | Å |
| MT2 | <result_code> (OK ERROR) |
|
|
|
|
|
|
|
|
|
5.5.1.3.Antenna Signal Level (AT$$ANTLVL)
The antenna level range is 0 (no service) to 7 (strong signal). If no changes are monitored $$ANTLVL does not report to $$ANTSET values.
Table
Notify | TE2 | Å | MT2 | $$ANTLVL: <value> |
Value |
| |||
|
|
|
|
|
If MT2 doesn’t receive a response (ACK) against ANTLVL, MT2 notifies two more times at the set interval irrespective to any changes to the level.
Extended AT Commands Manual | Page 25 of 70 |